Topic: Special tool required (Read 5768 times)

Jeepster · « **on:** March 19, 2005, 07:01:11 PM »

Help!!

Has anyone got the special tool that is need to take my rear diff apart( sorry i'm not very tecnical)or know where i can buy one.
I've got a '95 YJ with a busted rear bearing which is lovingly poring oil everwhere!!
I've been to the main dealer and apart from the fact they have never done this job before, they don't even sell the tool to do it! :smt017

Apparantly it's to undo a small nut to release the "c" clips in the diff.

Roland · « **Reply #1 on:** March 19, 2005, 08:07:35 PM »

:roll:

Bubba · « **Reply #2 on:** March 20, 2005, 08:30:57 AM »

is it the wheel bearing that has gone

Mike Pavelin · « **Reply #3 on:** March 20, 2005, 09:33:05 AM »

You need a 1/4" ring spanner to undo the retaining pin that holds in the shaft through the spider gears. Undo the pin, slide the shaft out, then push the halfshafts towards the centre of the axle to remove the C-clips.

Jeepster · « **Reply #4 on:** March 20, 2005, 11:09:10 AM »

Yeah Bubba i think its just the seal but i've all the parts just couldn't get the retaining bolt out

Bubba · « **Reply #5 on:** March 20, 2005, 05:18:21 PM »

should not be two hard to do dr bob has just posted exactly how to un do the c clips and just slide the shaft out if you do get any big problems i might be able to pop round for a look but should not be to bad

Jeepster · « **Reply #6 on:** March 21, 2005, 12:56:59 AM »

Thanks guys for all your help

=D> =D> =D>

Author Topic: Special tool required (Read 5768 times)

Jeepster

Special tool required

Roland

(No subject)

Bubba

(No subject)

Mike Pavelin

(No subject)

Jeepster

(No subject)

Bubba

(No subject)

Jeepster

(No subject)