Birty Dastards Jeep Club

Please login or register.

Login with username, password and session length
Advanced search  
Pages: [1]   Go Down

Author Topic: CRANKSHAFT POSITION SENSOR  (Read 1214 times)

0 Members and 1 Guest are viewing this topic.

petethejeep

  • Guest
CRANKSHAFT POSITION SENSOR
« on: July 17, 2014, 02:18:58 PM »
Hello,Hi
Please can anyone help me with the position of the Crankshaft position sensor on my 2.8l crd auto.
Had management light last on last week, did key off/on thing to see codes, then had it read & Crankshaft sensor was what came up on plugging in.Had codes cleared, to see if just a 1 off, obviously not, as same code is showing on display after doing the key in ignition thing. Same symptons as before, so ordered new sensor.
Now wondering whether easy fix I can do, or is it a garage jobby....
Logged

gazjeep

  • Marshal
  • Forum Member
  • *
  • Guru: 9
  • Offline Offline
  • Posts: 7280
  • Vehicle: TJ - Der Panzer - CBR
Re: CRANKSHAFT POSITION SENSOR
« Reply #1 on: July 17, 2014, 11:09:35 PM »
Should be un-plug old one from wiring & unscrew the sensor from the body as far as I know
Logged
Taking ya girl to heaven & back

petethejeep

  • Guest
Re: CRANKSHAFT POSITION SENSOR
« Reply #2 on: July 18, 2014, 09:20:50 AM »
Any ideas whereabouts it's located???????
Logged

gazjeep

  • Marshal
  • Forum Member
  • *
  • Guru: 9
  • Offline Offline
  • Posts: 7280
  • Vehicle: TJ - Der Panzer - CBR
Re: CRANKSHAFT POSITION SENSOR
« Reply #3 on: July 19, 2014, 10:10:18 AM »
Bugger, sorry just re-read your post, I was thinking TPS  :banghead:

Use the search on here, its been done before  :icon_winkle:
Logged
Taking ya girl to heaven & back

dieselj20

  • Guest
Re: CRANKSHAFT POSITION SENSOR
« Reply #4 on: July 19, 2014, 06:38:05 PM »
right hand side rear just above sump rail held in by one 6 mm bolt
Logged
Pages: [1]   Go Up
« previous next »
 
Powered by EzPortal