Birty Dastards Jeep Club
Tech Forum => Workshop => Topic started by: Bishops Finger on June 03, 2009, 09:19:36 PM
-
When me GC had its issues at year end it was found to be the passenger door control module needed replacing
Would the remote key fob have needed reprogramming afterwards????.........
Dr Mike, anyone thoughts pls...
-
is it not locking or somethin stew?
-
The module has to be programmed to accept the remotes IIRC. You need a DRBIII scan tool.
-
Hmm...so It may have been a good piece of customer service for the garage to have mentioned my spare remote needed rescanning......... :evil:
Is it a dealer only fix for this scan tool???
-
Yup
-
reply on behalf of the Bish......BUGGER !!! :lol:
-
Yup
Mike...Can but once again thank you for the advice ya give
Cheers
BF
oh and bugger...
-
Going to try local car leccy place mozza on the off chance...
-
Could have got a result..booked in at local Jeep place Sat am ..estimate is less than I've seen here for such work
-
Good luck young hobbit :icon_wink:
-
Cheers Gaz...failing that I'll hit it with sticks...;
-
A good birching should sort it :003: :003: :003:
-
Well apparantly the spare FOB was knackered and batteries were low...
Got GIVEN! a replacement programmed fob...just waiting for the labour bill... :jump_125:
-
lots :hysterical:
-
Be interesting..1 coffee and 20 minutes later twas out of said dealers....