Birty Dastards Jeep Club
Tech Forum => Workshop => Topic started by: Mutantdogboy on August 31, 2009, 03:46:55 PM
-
hi wonder if any one can point me in the right direction. got myself a hardtop for my tj wrangler.
on the down side its a from an older model maybe a wj. can any one tell me how to make it fit......
the seal at the top of the front windscreen has left small gaps at each side.... help mucho winter is fast approachin :jpshakehead:g
-
I believe your saying it's from a YJ and you have a TJ? If this is the case then your stuffed not interchagable!!!
-
i concour
only a tj one will fit
-
If it's from a WJ, then some git cut the roof of a poor bastard's Grand Cherokee with an angle grinder
and flogged it to you. Like Peter says, probably meant YJ.
We need to dig out an identification chart as it can be confusing at first.
-
My favourite guide......
Jeep Identification 101 (http://www.youtube.com/watch?v=VT3eHjlfNJA&eurl=http%3A%2F%2Fj33p%2Eorg%2F%5Fclub%2Fhome%2Ecfm#normal)
Top tune by CW Mcall too :003:
-
Nice picture at 46 seconds, not sure if i would have looked out of the drivers window
-
cool tune at the end. who was that?
-
foun it.
C.W. Mccall - Four Wheel Drive (http://www.youtube.com/watch?v=fUE2DTvltLI#normal)
-
sorry i did mean yj... so it wont fit!!!!! bugger!!!!!! I've put it on already it seames to fit apart from the seal round the wind shield any suggestions..........
-
it will fit - ive done it. you just have to remove the metal strip above the windshield and put a wider strip in. as for the gaps where the door, windshield and hardtop meet....... get creative. thats the only flaw. but it will fit