Birty Dastards Jeep Club
Tech Forum => Workshop => Topic started by: gazjeep on June 28, 2011, 09:45:55 PM
-
After busting & bending my disconnects at Clyro, can somebody (MOCAJ :003:) just check the length from end to end of the swaybar please.
Just want to make sure I haven't bent that too.
New Disconnects on order, best clean the bugger soon :icon_super:
-
i have one lay in the garage just now gaz, will measure tomoz and let you know
i wouldn't think you will have bent that, but will check :greggmo:
-
Cheers Steve :icon_winkle:
-
Gaz,
the distance between the centres of the bolts which hold on those 2 U shaped brackets for your disconects is 35"
-
Nice one Steve, i'll check tonight hopefully :icon_winkle:
-
that wont be bent unless there has been a reaction to all the polish
-
uri geller syndrome?
-
meow.....lol
that wont be bent unless there has been a reaction to all the polish
-
that wont be bent unless there has been a reaction to all the polish
Bitch :hysterical: :hysterical:
-
the weak point was the weld on the disconnect which as we know failed. if you had bent the sway bar then it would have bent with earlier in the day when the disconnect was intact
-
Just checking, I know they sit on an angle, the weld snapping is one thing but the other one being bent up too has made me think to check the sway bar before I fit the new ones :icon_winkle:
-
Just checking, I know they sit on an angle, the weld snapping is one thing but the other one being bent up too has made me think to check the sway bar before I fit the new ones :icon_winkle:
Breaking out the shiny spanners!
-
don't forget they are polished shiney spanners
-
so shiny he has to wear shades :greggmo:
-
Dont know why your looking so smug Kev, they will in all likely hood be done round yours :hysterical:
-
in the dirt and mayhem ?
-
u have got all that space
-
Gaz dude..bring them up the shire think even I can fit them...
-
Cheers Stew, its not the fitting, I would value MJS's opinion on the set up & angles especially laterally.
When viewing from the front, they seemed to lean out towards the wheel somewhat, hence me asking MOCAJ for length of sway bar ;)
Last MOT, I had to get new bushes for them as they seemed a little distorted, wondered if this was a contributing factor to recent failure ;)
-
Inverted!!!
-
We'll have none of that Blue Oyster shenanigans here if you dont mind :hysterical:
-
are you sure the sway bar hasn't moved itself too far to one side and now not central?
-
To be honest mate not sure, will have a good look when new ones turn up :icon_winkle:
-
Full balance owd lad