Birty Dastards Jeep Club
Tech Forum => Workshop => Topic started by: MudSurfer on August 16, 2011, 08:47:23 PM
-
The camshaft position sensor, EGR soleniod circuit, MAF circuit, and transmission control system too - I have a few fault codes that seem to come and go, and don't know where these things are - so I'd like to know where they are on the 2002 CRD engine, before I go off to SSJ or whatever they are called now, and get it plugged in.
TIA
-
The above are ghost codes - check the condition of your battery,
-
The above are ghost codes - check the condition of your battery,
Ghost codes???? The battery was new in January.....I'll not be using it this next week, so I'll take it out and stick it on charge and see what gives....
-
The above are ghost codes - check the condition of your battery,
As above I had the same on mine and it was just ghost codes, these came up because the one of the battery terminals were loose.
Lee
-
Cheers guys - battery out, had to modify the base of it so it would sit properly in the tray, then filed the insides of the terminal clamps so they were shiney and rough, did the same to the battery terminal posts, then widened the gap on each terminal clamp so when I re-tightened them, they closed better around the terminal posts. Gave them both a good dollop of copper grease and put it all back together. So, the battery is now sat firmly in the tray, which it wasn't before, and the teriminals are rock solid on the posts - out for a drive in a mo so will see.
No lighty, me likey - good times!!
-
bad battery connections cause soooooo many problems