Birty Dastards Jeep Club

Tech Forum => Workshop => Topic started by: jeep2019 on August 31, 2011, 04:04:46 PM

Title: Prop shaft lengths?
Post by: jeep2019 on August 31, 2011, 04:04:46 PM

Hi guys, I'm new to this forum and I'm trying to work out if I'm in the right section, apologies if I am not!

I have just removed my old 1976 258 IL6 with the 3 speed box and replaced it with a 1980 258 IL6 and a T-176 4 speed box. However, the front prop is too short and the rear prop is too long? Has anyone tried this modification and dose anyone know what my options are ie: do I have to buy new props, modify the original props or is there an alternative replacement.

Thanks Simon.

Title: Re: Prop shaft lengths?
Post by: Nosebolt on August 31, 2011, 04:24:48 PM

I went from a SR4 on a I6 to a T176 on a V8, I opted to have the rear custom made (over engineered according to some  :003: ) and the front re-tubed. I chose that route because of the lift I have and wanted a double cardon on the rear but a re-tube on the front and shorten the rear would be fine.

there is probably a set of props produced to suit that box axle combo but unless you find some good second hand units recon rebuilding is your best bet

Title: Re: Prop shaft lengths?
Post by: jeep2019 on September 01, 2011, 09:29:04 AM

Thanks Nosebolt really appreciate the reply. Where did you get your props custom made? I'm guessing any reputable engineering company could do this job?

Thanks again  :icon_biggrin: