Birty Dastards Jeep Club
Tech Forum => Workshop => Topic started by: Charl1e on March 29, 2012, 08:06:27 PM
-
Does anybody know or have any advice on how to get the T55 torx bolt out of the lower bracket on the anti roll bar???
So far i've gone through two T55's & one big breaker bar, I cant get access to any air tools this week either :011: think it must be welded on!!! but i'm out of ideas really and I dont want to round out the bolt, because that means drilling it out :jpshakehead:
-
soak it in your favourite lubricant, plug gas etc
then put torx driver in, hit it with a mallet a few times,
try your sockets, if that dont work its grinder time
-
soak it in your favourite lubricant, plug gas etc
then put torx driver in, hit it with a mallet a few times,
try your sockets, if that dont work its grinder time
They've been soaking in wd40 for over 24hrs, spraying every few hours, i'm going to get a bigger hammer!!
-
An Impact Wrench is gonna be your friend
-
i'm going to get a bigger hammer!!
When in trouble or in doubt.........get a bigger hammer out !!!!!! :icon_winkle:
-
An Impact Wrench is gonna be your friend
I'm going to try & get hold of one this saturday in work, but if not a bigger hammer it is :ace:
-
try soaking in ATF & thinners, sounds bizarre but was magic stuff (tip courtesy of irishcj6), makes wd40 resemble water
-
I'll mix some up in the morning, anythings worth a shot at this time :die:
-
Fairly sure there on splines into the braket so don't unscrew just knock out. Mine were anyway.
-
Fairly sure there on splines into the braket so don't unscrew just knock out. Mine were anyway.
Yep - 2 lump hammers and knock out
-
yup its on splines pressed in to bracket funny thing to do cos it sure looks like is should be threaded
-
:imwitstupid:
-
WD40 is not a penetrating fluid, is is an evapourating lubricant
-
grind off, drill it out, the bracket will bend like cheese :003: