Birty Dastards Jeep Club

Tech Forum => Workshop => Topic started by: rabbittmaster on April 12, 2012, 06:12:41 PM

Title: A quick question
Post by: rabbittmaster on April 12, 2012, 06:12:41 PM

(https://birtydastards.com/frm/proxy.php?request=http%3A%2F%2Fimg.tapatalk.com%2F5c06ac6e-094e-fe66.jpg&hash=780677507e954f8ee4b9bb5c5fd145c3f8e47a7a)

Here i have the coil from a 94' XJ Cherokee. I don't have the connector or wiring that is meant to fit on it. It is going on to my EFI conversion for a uni project. Therefore i am in a bit of a dilemma as to which is the positive prong and which is the negative prong. Can anyone help

Title: Re: A quick question
Post by: Cockney Boy on April 12, 2012, 06:24:08 PM

Do a continuity test between the pins on the loom and ground and find out which is which

Title: Re: A quick question
Post by: rabbittmaster on April 12, 2012, 06:36:42 PM

Sorry guv, i don't have the loom or connectors to do that.

Title: Re: A quick question
Post by: Cockney Boy on April 12, 2012, 06:39:08 PM

If you go on Morris 4x4 web site and do enough searching you should find a wiring diagram for it

Title: Re: A quick question
Post by: rabbittmaster on April 12, 2012, 06:53:47 PM

I don't think a wiring diagram is going to help me unless it is of the actual coil. I need to know which pin on the coil is positive and which pin is negative in relation to the connector locator.

Title: Re: A quick question
Post by: Cockney Boy on April 12, 2012, 07:13:47 PM

Well without the original loom or any kind of reference your up shit creek. Hopefully there maybe a member on later who might know

Title: Re: A quick question
Post by: Jonny Jeep on April 12, 2012, 08:11:45 PM

That coil connector looks different to the connector shown for XJs in 94 but it is the same as that used in the YJs of 94. This is from the 94 XJ/YJ FSM...

(https://birtydastards.com/frm/proxy.php?request=http%3A%2F%2Ffarm8.staticflickr.com%2F7262%2F7071537089_35c4b2dbc9.jpg&hash=f3d2b00b74eca20e3e2950977c5f2a7364e734a5)