Birty Dastards Jeep Club
Tech Forum => Workshop => Topic started by: biffo1 on January 15, 2013, 08:58:36 AM
-
Engine turns over but will not fire up suspect something to do with the immoboliser
-
Uh oh, seems Dutch was right :jpshakehead:
Unfortunately I have no useful knowledge in my head about this model but would suggest a scan for fault codes would be a good start.
-
check to see if fuel is getting through - could be stop/injection pump/blockage.
normal fault with immob is it starts and stops after a few seconds and lights on the dash showing a fault
or get it scanned - as if sensors/immob you would just chasing in the dark
-
I concur with Smigo...
-
Make sure you have fuel, manually pump the lift pump if no joy disconnect the pipe and drop it in a bottle of diesel and then try it.
Had exactly the same with my 2.8 KJ came to it one day it ran for a few seconds then cut out wouldnt start again just turned over
Turned out it was the lift pump / filter housing.