Post by: dodgyjeep on May 02, 2006, 08:41:50 PM
Got my husky mats winging there way over from the good ole u s of a and are getting ready to take the tj out for the first time since i bought her
just a few questions
where do you lot keep your hi lift as i have tried in the "boot" and it aint gonna fit
and also where have you mounted your cb, i cannot mount it on top of the dash because i have my locker switches mounted there
There is mounting kit on e bay but it requires a support bar running from one side of the roll bar to the other which i do not seem to have!!should I???
cheers in advance
mark :)
Post by: Dodster on May 02, 2006, 08:56:13 PM
I know some folks have strapped theirs to the roll bars in the rear... 8)
Hope thats of some use
Post by: dodgyjeep on May 02, 2006, 09:41:57 PM
like the look of your sill protectors, what make are they?
cheers
mark
Post by: Dodster on May 02, 2006, 10:27:36 PM
they were from Mountain Jacks who have since sold up and gone on to pastures new.
There are some similar at 4wd and Qtech i think they are Olympic rock rails..
Post by: Anonymous on May 02, 2006, 10:48:14 PM
Olympics do a good job check out 4wd or Quadratec to source them
Think Ponyracer and possibly Mik may also be able to offer something?
Post by: Woody on May 06, 2006, 10:54:24 AM
I have mine across my rear bars, you can see it in some of the photos here http://www.jeepclub.co.uk/reports.cfm?id=287 (http://www.jeepclub.co.uk/reports.cfm?id=287) green TJ with yellow advertising down the bonnet. I just got 4 exhaust U bolts that fitted round the sports bar and 2 lenghts of square steel tubing across the gap. Then bolted the 4xRac mounts to the tubing.
Must admit to being tempted by the bonnet mounting kits though.
Woody