Post by: Sam on March 04, 2007, 11:15:35 AM
Today i will mostly be crying and worrying. :(
my gears have been grinding for a while and in the last couple of days 1st and 2nd have been sometimes impossible to get (cant even grind it in - its as if they arnet there)
so today i got myself all motivated to check and change my fluids and have a little inspection- ha what a joke wish id never looked. boo hoo im nearly sniveling here. it looks like its bleeding from every orifice
is this normal (i suspect not)
(http://http://img.photobucket.com/albums/v479/sam123tom/me%20jeep/leakybits2.jpg)
(http://http://img.photobucket.com/albums/v479/sam123tom/me%20jeep/frontdiffbleeding.jpg)
oh and whats this hole
(http://http://img.photobucket.com/albums/v479/sam123tom/me%20jeep/hole2.jpg)
its just a hole it was all chocka with mud so i srcaped it all out and you can poke a screwdriver right in it. (http://http://img.photobucket.com/albums/v479/sam123tom/smileys/speechless-smiley-023.gif)
As for changing fluids - sounds easy in the haynes book but i cant figure out which are drain and fill holes (the pictures in the books look nothing like mine). in fact the damn book is tottaly pants and at the mo i wanna jump up and down on it whilst shouting obscenities loudly. :cry:
any advise apreciated
oh im totally fed up now What am i gonna doooooooooooooooooooo
regards
destressed and panick stricken jeep owner
off for a stiff drink 40 fags and a dozen cadburys cream eggs.........
Post by: isle of man on March 04, 2007, 11:27:19 AM
(http://http://img.photobucket.com/albums/v479/sam123tom/me%20jeep/frontdiffbleeding.jpg)
peter henry
Post by: king cj on March 04, 2007, 01:21:44 PM
the other bolt half way up the side of the gearbox above the drain hole is where you put the new oil in untill it starts to come out of the same hole your filling it through.
Post by: Sam on March 04, 2007, 02:03:41 PM
Quote from: "isle of man"
pinion seal it's no big deal as it is not uncommon for the nut to back off......
no big deal well thats what i like to hear, should i just try tightening the nut or buy a new seal and fit:?
Quote from: "king cj"
changing fluids, big bolt on the bottom of gearbox side drops the oil.
the other bolt half way up the side of the gearbox above the drain hole is where you put the new oil in untill it starts to come out of the same hole your filling it through.
ooh jonny you make it sound so simple (well it probably is if your you and not me) sorry to be a complete pain in the jacksy and thanks for the help. But in the book it says the drain and fill holes are on opposite sides but i dont really believe that as the pictures in there dont look anything like my GB. your instructions are fab and i reckon it would be easy enough, i think i can see the drain one BUT there are about 5 others above and around this one the same side (and some on the other side)and im not sure which is the correct fill hole. i wish they would label these things.
(http://http://img.photobucket.com/albums/v479/sam123tom/me%20jeep/oilchange.jpg)
fill hole ??????????????????
Post by: greggmo on March 04, 2007, 02:21:37 PM
Post by: Sam on March 04, 2007, 02:27:13 PM
oh hell its chucking it down out there now bugger. think im off to match dot com to see if any mechanics want to marry me.....................
Post by: ponyracer1 on March 04, 2007, 02:37:57 PM
If you have never changed it you should pull the diff covers and drain the oil.
Clean the cover and the housing where the bolts go in nice and clean, let all the oil drain out, put a continuous bead (diam of a pencil) of black or red rtv around the cover. Center the rtv over the bolt holes. Let it tack up for 15 mins or so and lightly stick it on the housing. Put all the bolts in finger tight then snug them down a little till the rtv starts squeezing out. Let them sit for a few hrs then refill it till the oil runs out the fill hole. Make sure you put additive in the rear if you have a D35.
From then on just make sure you keep it topped up. If your seal isn't so bad that it leaves drips in the drive then don't worry about it. Save that job for when you put in lockers!!
As far as the tranny, sounds like she may have bad syncro's. Nothings gonna fix that but a rebuild. Try the oil though, ya never know. Try full synthetic also.
Post by: Sam on March 04, 2007, 02:49:44 PM
Quote from: "ponyracer1"
Save that job for when you put in lockers!!
ha bloody ha who are you trying to kid :lol:
can do without summat else to go wrong
no honest thanks for the info though
im learning....................
Post by: ponyracer1 on March 04, 2007, 05:32:31 PM
Quote from: "Sam"
ha bloody ha who are you trying to kid
Just
Empty
Every
Post by: jeepey on March 05, 2007, 08:05:39 PM
http://http://www.stu-offroad.com/index.html
check out the menu's on thesite, here's one for the gearbox
http://http://www.stu-offroad.com/engine/ax-15/ax-15-1.htm
I know its a TJ based site, but most parts are the same across the 2 models. hope you get sorted. i know how it feels
Post by: jeepey on March 05, 2007, 08:11:57 PM
also worth checking the TJ write up section cos theres loads and loads of stuff on thesre, that will be the simular, if not the same to a XJ
http://http://www.4x4xplor.com/mods-XJ.html
Post by: ponyracer1 on March 05, 2007, 09:40:16 PM
http://www.naxja.org/forum/ (http://www.naxja.org/forum/)
If you register you can search.
Post by: Sam on March 05, 2007, 10:40:29 PM
heres to a weekend that is a bit more sucsessful than the last :? . you watch, knowing my luck there will be a flash flood on friday night:lol: