Birty Dastards Jeep Club

Tech Forum => Workshop => Topic started by: Groove Rider on November 07, 2007, 02:12:45 PM

Title: Is this going to do the job......
Post by: Groove Rider on November 07, 2007, 02:12:45 PM

Will this do the job of pulling out my XJ rear wheel bearings??

http://cgi.ebay.co.uk/NEW-9pce-Auto-Bod ... dZViewItem (http://cgi.ebay.co.uk/NEW-9pce-Auto-Body-Repair-Slide-Hammer-Kit-5lb_W0QQitemZ300168605563QQihZ020QQcategoryZ303QQtcZphotoQQssPageNameZWDVWQQrdZ1QQcmdZViewItem)

Cheap....... but is it nasty :)

Title:
Post by: greggmo on November 07, 2007, 05:33:11 PM

it should certainly help. ya can always just destroy the old bearings as long as you dont send bits down the tube into the pumpkin.

Title:
Post by: Mik on November 09, 2007, 11:06:36 AM

All you need is a 12 point 1/4 ring spanner and a length of steel rod about 20mm diameter, a foot longer than your axle.

Use the spanner to release the screw in the diff holding the cross pin in. Remove ( or half remove) the cross pin and then insert your rod in the axle, through the diff and use it to punch out the bearings from behind.

Peasey.

Title:
Post by: greggmo on November 09, 2007, 08:34:42 PM

or like mik said ya can do it the engineers way :lol: