Birty Dastards Jeep Club

Tech Forum => Workshop => Topic started by: YZF426 on November 26, 2007, 09:59:39 PM

Title: 360 VVVVVVVV88888
Post by: YZF426 on November 26, 2007, 09:59:39 PM

8) knowledgeable Birtys.
Are the engine mounts for the V8 the same as the 4.2.
YZF426

Title:
Post by: Bubba on November 26, 2007, 10:06:25 PM

no.he he

Title:
Post by: YZF426 on November 26, 2007, 10:08:26 PM

Best place to get them  :P

Title:
Post by: Bubba on November 26, 2007, 10:21:24 PM

to do it neatly you will find that the engine block steel mounts are wrong unless it came from a cj just buy them from lighthouse around a tenner a side you will also find that the left hand chasis mount is slightly off it has a slight kink /slope in it but it is easy to correct with a bit of flat plate and a drill or just buy one from lighthouse up to you the fuel pipe will need to come up to the engine on the other side from the from a 4.2 as the fuel pump on the 360 is the wrong side  the 360 ignition just plugs straight in to the harness if its the same motorcraft ignition module as 4.2 not sure for you as you only had half an engine to start with you will a flywheel from a 4.2 and proly a 4.2 clutch as i am not sure about your clutch from the 151 lump you had got

Title:
Post by: Bubba on November 26, 2007, 10:22:46 PM

o and the rubber mounts must be for a v8

Title: Re: 360 VVVVVVVV88888
Post by: isle of man on November 26, 2007, 10:23:41 PM

Quote from: "YZF426"

:lol:
Will need to start as I mean to go on, a few queries for you  :wink:

try.......... http://http://72.20.96.178/commerce/ccc1061-1997-2005-wranglers.htm




peter henry

Title:
Post by: tag on November 26, 2007, 10:44:37 PM

Check out these suckers,        http://www.britishamericanengines.co.uk/vid_gallery.asp (http://www.britishamericanengines.co.uk/vid_gallery.asp)

Title:
Post by: YZF426 on November 27, 2007, 10:12:10 PM

Sent em an email cheers