Birty Dastards Jeep Club
Tech Forum => Workshop => Topic started by: big g on September 06, 2008, 09:22:29 PM
-
Will an 94 rear axle bolt up to a 98 facelift model or is it a hassle swapping bits to match 'em up???
Appologies if this has been covered before.
-
In short yes they will
Depends on what maodels you are talking about though
A 4 litre on a 98 is an open diff Dana 35
the same on the 94 will have an LSD but is still a Dana 35
The 2.5 petrols have a Chrysler axle with an LSD
2.5 deisels have Dana 35's with LSD
look out for the gear ratio's also
Make sure if you need ABS you get one with it also
-
A 94 may not have ABS sensors
-
Cheers for the info.
It's a 98 4.0 so it may be gettin a slipper,I'll speak to the man.The ABS may have to binned.
Least they're both Dana 35's so swapping shouldn't be too much of a pain.Take it the ratios weren't altered on that axle over the yrs??
-
Cheers for the info.
It's a 98 4.0 so it may be gettin a slipper,I'll speak to the man.The ABS may have to binned.
Least they're both Dana 35's so swapping shouldn't be too much of a pain.Take it the ratios weren't altered on that axle over the yrs??
The gearing should be the same (unless tow packages etc were used :wink:
http://cgi.ebay.co.uk/ws/eBayISAPI.dll? ... :IT&ih=006 (http://cgi.ebay.co.uk/ws/eBayISAPI.dll?ViewItem&rd=1&item=160279401231&ssPageName=STRK:MESE:IT&ih=006)
-
Our lasses Voyager came back from it's test with a fair old list so the axle will be on hold for a while,unless there's a catastrophic moment.
Thanks away-I'll bear it in mind if you don't sell it this time.