Birty Dastards Jeep Club
Tech Forum => Workshop => Topic started by: Nosebolt on March 01, 2009, 07:10:38 PM
-
Today I jet wash the T176 I got yesterday from Bubba (Thanks again). I was going to use original bell housing but use the fork gator of the one that came with the T176, nearly shat myself when I found the hole was almost 3/4” smaller on old bell housing.
Anyway took off the bell housing that came with the SR4 and while all holes are identical they are definitely different castings.
Have decided to use the bell housing that came with the T176 mainly because I had already jet washed the outside while cleaning the rest of the gearbox. Should all go together tomorrow and then just a wait for the new yoke for the transfer case to rear prop.
-
castings wont be the same as not made by the same companys but they will fit the engine the same the forks may vary slightly but should work the same as almost certain there is onlt one part no for cjs of that era