Birty Dastards Jeep Club

Tech Forum => Workshop => Topic started by: bluesleeper on April 02, 2009, 06:26:18 PM

Title: 2000 cherokee towbar wiring
Post by: bluesleeper on April 02, 2009, 06:26:18 PM
Hey there guys, just wondering where the best place to pick the wiring up for towbar electrics is?
are there any pre cut holes to thread the wiring through or where is the best place to dril??
Any info/ pics/advice will be gratefully recieved!

Cheers,

Gareth.
Title: Re: 2000 cherokee towbar wiring
Post by: Dave69 on April 02, 2009, 08:26:39 PM
one place is to pull a light cluster out and connect to the relevant lights. there should be a gromment just below that goes into the wheel arch which you can drill and feed a wire through
Title: Re: 2000 cherokee towbar wiring
Post by: Mike Pavelin on April 02, 2009, 10:18:28 PM
Go to Halfords and get a wiring kit.
Title: Re: 2000 cherokee towbar wiring
Post by: bluesleeper on April 03, 2009, 10:19:37 AM
I have the wiring kit ready, I just wanted to know which side was best to connect to because i will need wiring for both indicators etc and if there were any existing holes i can utilise for the wiring.

Thanks for the input guys,

Gareth.
Title: Re: 2000 cherokee towbar wiring
Post by: neilhull on April 03, 2009, 09:04:08 PM
Fitted wiring on the drivers side on my cherry . there is not much room on the passengers side as you have the petrol filler .    I ran a two wire from the passenger side to the drivers side this i ran under the plastic trim at rear of boot .
  To get the towbar wire in to the drivers side i took the light cluster of and drilled a hole just below it