Topic: On the scrounge....... (Read 5378 times)

Ric Jacques · « **on:** January 13, 2006, 06:15:31 PM »

If any of you guys have a garage full of CJ bits (winks at Bubba) perhaps I might be able to scrounge a couple of things - I'm thinking about you guys who have done the rear disc conversion on yer CJs.

I'm looking for the two little pushrods that go into the rear wheel cylinders (thereby hangs a tale of my own stupidity...) and also the little dust cover thing that sits over the rear wheel bearings inside the drum brake back plate ( Item 16 )

Any help much appreciated.

Anonymous · « **Reply #1 on:** January 13, 2006, 07:30:03 PM »

I think that any parts should be witheld until the full story is told in glorious technicolour of what RJ did that was so silly :twisted:

Ric Jacques · « **Reply #2 on:** January 13, 2006, 10:16:19 PM »

OK OK OK!

Picture my eager anticipation of the impending arrival of my box full of bits from Florida. So I gets stuck into the left rear brake stuff - rusty as hell. All of it. So I strip out the shoes, springs, blah blah blah. The wheel cylinder is just a ball of rust.

So I thinks hmmmmm I got a new one arriving this week. So I tossed it. All of it.

WELL I DIDN'T KNOW THE "ROCKING HORSE SHIT" PUSHRODS (WHICH WERE NOT SO RUSTY :oops:

So when my stuff arrived I was like a 2 year old at christmas.

Until I got to the wheel cylinders.

Find me some and I may confess to more.........fuck I should write a book!

trent · « **Reply #3 on:** January 13, 2006, 10:22:58 PM »

Ouch, i'm feelin for ya there buddy.
Hope Bubb's can help ya :roll:

king cj · « **Reply #4 on:** January 14, 2006, 12:33:50 PM »

i probably have the push rods kicking about but dont think i can help with the seal unless it the same as a d44 one.

Author Topic: On the scrounge....... (Read 5378 times)

Ric Jacques

On the scrounge.......

Anonymous

(No subject)

Ric Jacques

(No subject)

trent

(No subject)

king cj

(No subject)