Topic: Blue touch paper lit, what's next? (Read 1191 times)

eastryjeep · « **on:** August 07, 2013, 09:16:07 PM »

OK, I still can't get this 258 to start, and I'm not going back to a carb.
What I need to know is how to independently test all the sensors that a '94, 4.0 litre Auto XJ would have had as standard, as Im afraid I don't have a workshop manual.
For each of the following, can some kind soul(s) tell me what supply current to apply on what wire, and what is the acceptable output from the signal wire/terminal:-
MAP, Air Temp, Coolant Temp, Throttle Position, Lambda, Crank sensor and Hall Effect Distributor.
Thanks,
Nick.

isle of man · « **Reply #1 on:** August 07, 2013, 09:21:13 PM »

Try these people... http://www.splitsec.com/index.html they helped me with the supercharger on my jeep.

eastryjeep · « **Reply #2 on:** August 07, 2013, 09:38:45 PM »

Thanks IOM but need to see if the sensors are toasted before going along that route.
Can anyone tell me how to check the CPS & TPS off the vehicle?
Also does anyone have a PDF of a workshop manual for a 94 XJ, PLEASE!

Jonny Jeep · « **Reply #3 on:** August 07, 2013, 10:07:56 PM »

Might have.

PM sent.

bluevanman · « **Reply #4 on:** August 07, 2013, 10:08:54 PM »

last time I done a tps it just needed a multimeter set to ohms then read it thru the full turn but it wasn't on a jeep oh and analogue meters better any dead spots are more obvious

Author Topic: Blue touch paper lit, what's next? (Read 1191 times)

eastryjeep

Blue touch paper lit, what's next?

isle of man

Re: Blue touch paper lit, what's next?

eastryjeep

Re: Blue touch paper lit, what's next?

Jonny Jeep

Re: Blue touch paper lit, what's next?

bluevanman

Re: Blue touch paper lit, what's next?