I seem to have l a brake issue
this is a picture of my rear Rubicon Axle, It arrived this week and this is what I found while unwrapping it.
Before I install it, I need to do something about the stub of a hard brake line. Its broken off with about a 1" stub left. Is this something that can be readily fixed?
Will it be possible to flare the end and plumb in a new line?
Can it be heated and removed from the block , and a new line soldered in?
Can I remove the block and install another,
or do I have to fill in the existing holes, and install a new "t" on of the existing block, to run the brake lines
Is this something I need to load up and have a pro repair? any help would be appreciated...
Cheers , Martyn