Topic: TJ Starter Motor (Read 8329 times)

ivanidea · « **on:** May 17, 2008, 02:03:46 PM »

My starter has decided not to work.

Last weekend, it turned on the 2nd attept of turning the key, now it won't even turn at all.

The battery voltage seems to be fine.

Is there anything I can do to try and get the Jeep started, at least so I can drive to my local friendly mechanic. I assume I will need a new starter.

Where do I aim the big hammer (haven't got a clue where the starter is located)? Could it be a bad electrical connection?

Ivan

ivanidea · « **Reply #1 on:** May 17, 2008, 03:33:51 PM »

I've just been told to keep trying, and after 2 minutes it started.

Ivan

greggmo · « **Reply #2 on:** May 17, 2008, 10:12:45 PM »

it is most likely in need of a strip down and clean and grease. the solenoid may well be your problem mate. the starter is located on the drivers side of the gearbox bell housing and easy enough to get off. just make sure you disconnect the battery before you take off the starter and you can easily ground em out.

Bishops Finger · « **Reply #3 on:** May 17, 2008, 10:22:14 PM »

Clued in auto eectrcal place should be able to rebuild with a warrenty..

CPC in Telford did mine a couple of years ago..

Dodster · « **Reply #4 on:** May 17, 2008, 11:07:51 PM »

Here is a 'strip and clean' link if its any use. Its for an XJ but is just the same..

http://www.go.jeep-xj.info/HowtoStarterClean.htm

Roland · « **Reply #5 on:** May 18, 2008, 08:16:58 AM »

Author Topic: TJ Starter Motor (Read 8329 times)

ivanidea

TJ Starter Motor

ivanidea

(No subject)

greggmo

(No subject)

Bishops Finger

(No subject)

Dodster

(No subject)

Roland

(No subject)