Birty Dastards Jeep Club

Please login or register.

Login with username, password and session length
Advanced search  
Pages: [1]   Go Down

Author Topic: Torn pipe (Axle breather?)  (Read 5255 times)

0 Members and 2 Guests are viewing this topic.

jeep94

  • Guest
Torn pipe (Axle breather?)
« on: July 31, 2007, 07:53:27 PM »

Just been checking under the Jeep after a bit of off-roading, just to make sure all is ok. Happen to notice a small rubber pipe about two foot long (with a torn end?), leading from the top of the front diff casing (top right looking from underneath towards the front). Is this the axle breather, and if so, where should it go?

 :-k  :-k
Logged

greggmo

  • Founder
  • Forum Member
  • *
  • Guru: 2
  • Offline Offline
  • Posts: 8230
(No subject)
« Reply #1 on: July 31, 2007, 08:13:40 PM »

tis the axle breather and it just needs to go as high as its length will allow. make sure it is away from the exhaust and rotating parts. 8)
Logged

jeep94

  • Guest
(No subject)
« Reply #2 on: July 31, 2007, 08:29:15 PM »

So were does it normally go? The end isn’t a straight cut, more of a diagonal rip? Is there one on the rear axle too?

 :oops:  :oops:
Logged

greggmo

  • Founder
  • Forum Member
  • *
  • Guru: 2
  • Offline Offline
  • Posts: 8230
(No subject)
« Reply #3 on: July 31, 2007, 08:34:04 PM »

yes there is one on the back too. if the front one looks torn it might be just that. it should have a little plastic valve in the end if it is all there.. as for the exact routing i aint sure...one for the dr mike or one of the other cherry guys.
Logged

Mike Pavelin

  • Guest
(No subject)
« Reply #4 on: July 31, 2007, 08:41:44 PM »

It normally runs up the firewall on the passanger side of the engine and is cable tied to the wiring harness.
Logged

jeep94

  • Guest
(No subject)
« Reply #5 on: July 31, 2007, 09:06:30 PM »

I guess this will be an ideal time to extend my axle breathers into the snorkel!!! What type and size rubber tube is it?
Logged

DarrenR

  • Forum Member
  • *
  • Guru: 0
  • Offline Offline
  • Posts: 303
  • Vehicle: 2.7 grand Cherokee overland
  • Year: 2003
(No subject)
« Reply #6 on: August 01, 2007, 06:33:26 PM »

think its 9.5 fuel hose, cut a bit off and take it with you to motor factors.

Darren
Logged
Can't keep away from the bloody things

greggmo

  • Founder
  • Forum Member
  • *
  • Guru: 2
  • Offline Offline
  • Posts: 8230
(No subject)
« Reply #7 on: August 01, 2007, 10:27:50 PM »

the in the snorkel thing has always puzzled me a bit really... in the event of an axle over heating eg mad gearing+motorway trip=oil sometimes will exit via the breather therefore filling your air box with diff oil and i cant see it doing any good to be honest. mine are just up as high as poss and the tops of them always look well below the mud/waterline also most contamination happens through the axle seals themselves so moving the breathers seems a bit of wasted effort to me. what do you all think on this one??? cos i for one don't see it. :shock:
Logged

tim_aka_tim

  • Club Member
  • Forum Member
  • *
  • Guru: 1
  • Offline Offline
  • Posts: 4464
  • Vehicle: Honda Pilot
  • Year: 2008
  • Regional Organiser North America
(No subject)
« Reply #8 on: August 01, 2007, 10:38:43 PM »

The breathers come out fairly near the top of the engine bay anyway, so I don't personally see a need for it, but it's not going to cause any damage if diff oil did get into the airbox - the airbox would happily take the all the oil from both diffs and still have room for airflow. Diff oil is horrible shit though and I wouldn't want it anywhere other than in the diffs.
Logged
Pages: [1]   Go Up
 

Powered by EzPortal