Birty Dastards Jeep Club

Please login or register.

Login with username, password and session length
Advanced search  
Pages: [1]   Go Down

Author Topic: 2.5 td XJ knock, bang noise  (Read 5920 times)

0 Members and 1 Guest are viewing this topic.

coz

  • Guest
2.5 td XJ knock, bang noise
« on: October 05, 2007, 10:16:42 AM »

ive got a xj 2.5 td 1999 facelift done 90k

developed an occasional thud, knock niose when pulling off - more noticeable if car is loaded up or trailer attached

My mechanic has checked all UJ's, shock mounts, exhaust hangers etc and found nothing

he said gearbox output shaft had some play but not hugely significant

Ive just read about the chain thing in transfer box, could it be that, its doing it in 2wd tho

any ideas
Logged

Manda

  • AKA Dangerous Doris
  • Founder
  • Forum Member
  • *
  • Guru: 0
  • Offline Offline
  • Posts: 3322
(No subject)
« Reply #1 on: October 05, 2007, 10:48:40 AM »

I may be wrong and they'll tell me if I am, but it could be the LSD in you back axle. They get worn out and clonk and bang when they're warm and you pull away.
Logged
AKA Dangerous Doris

coz

  • Guest
(No subject)
« Reply #2 on: October 05, 2007, 11:09:34 AM »

i thought only the 4.0 had LSD

but am waiting to be corrected -
Logged

mikeh

  • Guest
(No subject)
« Reply #3 on: October 05, 2007, 12:39:19 PM »

Quote
LOW SPEED KNOCK
Low speed knock is generally caused by a worn
U–joint or by worn side–gear thrust washers. A worn
pinion gear shaft bore will also cause low speed
knock.

DRIVELINE SNAP
A snap or clunk noise when the vehicle is shifted
into gear (or the clutch engaged), can be caused by:
² High engine idle speed
² Loose engine/transmission/transfer case mounts
² Worn U–joints
² Loose spring mounts
² Loose pinion gear nut and yoke
² Excessive ring gear backlash
² Excessive side gear/case clearance
The source of a snap or a clunk noise can be determined
with the assistance of a helper. Raise the vehicle
on a hoist with the wheels free to rotate. Instruct
the helper to shift the transmission into gear. Listen
for the noise, a mechanics stethoscope is helpful in
isolating the source of a noise.


From the book  :wink:
Logged

coz

  • Guest
(No subject)
« Reply #4 on: October 05, 2007, 01:01:22 PM »

thanks, thats helpful, will check it out more
Logged

barttheguinnessguy

  • Forum Member
  • *
  • Guru: 0
  • Offline Offline
  • Posts: 180
  • Vehicle: Liberty 2.8 CRD
  • Year: 2003
  • Just one step away, from being a full blown pikey
(No subject)
« Reply #5 on: October 05, 2007, 04:42:05 PM »

Mine did the same sort of thing. Turned out it was the shocks moving on the bar pins :wink:
Logged
It's a thankless task, but I've got a lot of Karma to burn off! I'm just tryin to be a beter person. My name is Bart.
03 KJ 2.8 CRD Limited. 90 MJ 4.0 Short Bed. 44 GPW

coz

  • Guest
(No subject)
« Reply #6 on: October 05, 2007, 07:51:26 PM »

Quote from: "barttheguinnessguy"
Mine did the same sort of thing. Turned out it was the shocks moving on the bar pins :wink:


where did you get them from
Logged

Bubba

  • "Cooter"
  • Marshal
  • Guru
  • *
  • Guru: 69
  • Offline Offline
  • Posts: 21029
(No subject)
« Reply #7 on: October 05, 2007, 08:39:27 PM »

might be might not
Logged


trucks


shedric
cletus
mr whippy

I spent most of my money on alcohol, women and old  iron........ the rest of it I just wasted.

Dave69

  • Club Member
  • Forum Member
  • *
  • Guru: 15
  • Offline Offline
  • Posts: 9457
  • Vehicle: CJ-7 4.2 auto
  • Year: 1979
(No subject)
« Reply #8 on: October 05, 2007, 08:42:19 PM »

the derv jeeps had the LSD in the rear and for some reason they weren't fitted to the petrol.

clunking or juddering from take off could be the clutch pack in the rear diff not working or it could be the clutch. When i had mine the rear diff was fine but i found the clutch was knackered. worn finger splines and the pressure plate springs had worn away good parts of the pressure plate
Logged
XJ 2.5 diesel - dead. XJ 4.0 6" lift - sold to some lucky person
CJ7 4.2 auto standard(ish)
Alfa 147 jtdm

Bubba

  • "Cooter"
  • Marshal
  • Guru
  • *
  • Guru: 69
  • Offline Offline
  • Posts: 21029
(No subject)
« Reply #9 on: October 05, 2007, 09:30:14 PM »

i think you may have wrote that the wrong way round it may be a sheared gearbox or engine mount
Logged


trucks


shedric
cletus
mr whippy

I spent most of my money on alcohol, women and old  iron........ the rest of it I just wasted.

barttheguinnessguy

  • Forum Member
  • *
  • Guru: 0
  • Offline Offline
  • Posts: 180
  • Vehicle: Liberty 2.8 CRD
  • Year: 2003
  • Just one step away, from being a full blown pikey
(No subject)
« Reply #10 on: October 07, 2007, 06:22:04 PM »

Quote from: "coz"
where did you get them from


Rocky Roads Outfiters. http://http://www.rocky-road.com/xjbarpin.html
Logged
It's a thankless task, but I've got a lot of Karma to burn off! I'm just tryin to be a beter person. My name is Bart.
03 KJ 2.8 CRD Limited. 90 MJ 4.0 Short Bed. 44 GPW

Sam

  • Guest
Re: 2.5 td XJ knock, bang noise
« Reply #11 on: October 19, 2007, 06:37:13 PM »

Quote from: "coz"
ive got a xj 2.5 td 1999 facelift done 90k

developed an occasional thud, knock niose when pulling off - more noticeable if car is loaded up or trailer attached



aye mine does it too (has done for ages- bout a year) two of my mates with the same cars theres does it to.

between the three of us weve found it v.hard to see whats wrong (all above mentioned things checked and fine). mine started after i trashed a crossmember and knocked the transfer box out of place (since been fixed but still does it) we think its the prop knocking on something but cant suss it out.

i ignore mine now ive gotten used to it (although when its in 4WD and pushed real hard like when trying to get up a major steep hill offroad it sometimes feels like the prop is coming through the passenger floor :oops:

if you fathom it out let us know  :D
Logged
Pages: [1]   Go Up
 

Powered by EzPortal