July 04, 2025, 06:12:10 AM
Welcome,
Guest
Please
login
or
register
.
1 Hour
1 Day
1 Week
1 Month
Forever
Login with username, password and session length
Home
Forum
Help
Login
Register
GALLERY
Unread
Events
Birty Dastards Jeep Club
>
Forum
>
Tech Forum
>
Workshop
>
Topic:
Whats This?
« previous
next »
Pages: [
1
]
Go Down
Print
Author
Topic: Whats This? (Read 8161 times)
0 Members and 1 Guest are viewing this topic.
mike213735
Guest
Whats This?
«
on:
January 28, 2009, 07:26:21 PM »
I have been looking at pictures online of the engine in 4.0L Cherokees.
Mine is a 1995 Auto and I have a big flat plastic box on top of the throttle body which is like a flat air filter box. This is inline between the air filter and the throttle body.
Any ideas what it is and what it does?
I can supply images if required.
Thanks
Mike
Logged
scrw
Guest
(No subject)
«
Reply #1 on:
January 28, 2009, 08:30:48 PM »
about 1 foot square and a couple of inches deep? if so its a sound muffler, not sure what year they started fitting them
Logged
Mike Pavelin
Guest
(No subject)
«
Reply #2 on:
January 28, 2009, 08:31:58 PM »
It's a plenum chamber.
Logged
mike213735
Guest
(No subject)
«
Reply #3 on:
January 28, 2009, 08:48:09 PM »
scrw,
Yes, it's about a foot square and a couple of inches deep and made out of plastic.
Can I remove it and just buy the inlet hose that runs from the air filter to the throttle body and if so, would there be any point?
Thanks
Mike
Logged
Panic mechanic!
Guest
(No subject)
«
Reply #4 on:
January 28, 2009, 08:51:35 PM »
there's no point in changing it for the earlier version,apart from that its somewhere to put your cuppa when you are workong on the engine
Logged
Dave69
Club Member
Guru
Guru: 15
Offline
Posts: 9457
Vehicle: CJ-7 4.2 auto
Year: 1979
(No subject)
«
Reply #5 on:
January 28, 2009, 09:19:04 PM »
those little or big plastic add on boxes to the inlet system are there for a reason. when a vehicle is developed they start with an airbox and a straight tube to the engine. A calculation for flow and resonance is done, this gives a figure where the inlet will resonate at a peak frequency which then might become intrusive to the driver inregards to noise. this little empty box creates an opposite frequency which cancels out the obtrusive peak frequency thus giving a quiet and acceptable intake noise. This also helps the car to pass the noise homologation requirements.
if you need to remove this additional box then it will cause no harm to the engine, but replace the intake tube with a hose of the same diameter as the origional so you can put it back to standard if required later.
Logged
XJ 2.5 diesel - dead. XJ 4.0 6" lift - sold to some lucky person
CJ7 4.2 auto standard(ish)
Alfa 147 jtdm
Print
Pages: [
1
]
Go Up
« previous
next »
Birty Dastards Jeep Club
>
Forum
>
Tech Forum
>
Workshop
>
Topic:
Whats This?
Powered by
EzPortal
Go Up
Go Down