Birty Dastards Jeep Club

Please login or register.

Login with username, password and session length
Advanced search  
Pages: [1]   Go Down

Author Topic: A couple of questions  (Read 2250 times)

0 Members and 1 Guest are viewing this topic.

Jamie Read

  • Guest
A couple of questions
« on: October 24, 2011, 04:10:07 PM »
I`m getting a warning on the display that says "coolant temp sensor bad" - do I need to replace it? Can I get one from the local motor factors? And probably most imporantly..... where is it on the motor?? :017:

Next- I`m getting a rattling from underneath, sounds sort of exhaust related, I think I`ve located it to the catalytic converter, as when i tap the cat something bounces inside.... is the cat goosed?
Logged

Nosebolt

  • Guest
Re: A couple of questions
« Reply #1 on: October 24, 2011, 04:13:47 PM »
My cats fubard too, not to worried till MOT is due but would be interested in cost of replacement
Logged

Jamie Read

  • Guest
Re: A couple of questions
« Reply #2 on: October 24, 2011, 04:15:56 PM »
Well I`ve found one on eblag for £70 inc. postage, there is another for £47 but it didn`t look as good
Logged

Jamie Read

  • Guest
Re: A couple of questions
« Reply #3 on: October 24, 2011, 07:56:08 PM »
Since discovered that the "coolant temp sensor bad" message could be due to a broken solder on the display.
The message seems to come and go.

Oh, and I should add that its going for is test tomorrow!
Logged

Jamie Read

  • Guest
Re: A couple of questions
« Reply #4 on: October 25, 2011, 12:29:44 PM »
Grrrrr!.......... started heading to mot, stopped halfway to see smoke/steam coming from rear wheels..... Handbrake adjusted up too tight!! Turned round, headed home to cool `em off and adjust later  :banghead:
Logged
Pages: [1]   Go Up
« previous next »
 
Powered by EzPortal