Hi All
I am seriously considering x2 Cree lights for the Wrangler.
One above the windscreen and one on the front bumper. Anyone had this done = looking for advice re model to buy etc and any problems identified.
I have the windscreen light surround and bumper light brackets.
Appreciate any guidance.
S
Make sure it's Cree.
I wasn't paying attention, and ended up with a 30" epistar bar,, they're weak compared to Cree, I could see the difference as soon as I hooked it up to the test battery I had. Junk the stock ally mount brackets, make your own in steel. You can mount them lower, and allows for a tack weld on the mount bolts to keep them safe from sticky fingers.
Usual US set up of choice is a 20 or 30" on the bumper and a 50" on the roof for wranglers. I had a 20/30/40 set up that also work.
As a guide,
20" Cree is more than enough for most needs.
60" Cree is bloody hilarious amount of light.
90" Cree is way OTT, and hazardous for other road users.
I've seen some US wranglers with 200"+ of bars ! Worse part was, they where RI bars, that DON'T use Cree chips, and they'll relieve you of circa $1500 for a 50" bar !
