Topic: Dog guard refurb (Read 9072 times)

pajero · « **on:** February 08, 2009, 02:24:31 PM »

The plastic coating is coming off the frame of the dog guard. It is still well attached to the wire section. It is also stuck to a few bits of the frame.

Has anybody got any bright ideas about refurbing the guard? The frame is rusty where the plastic has come off so obviously has to be sanded back.

As for the wire section, leave it alone, or is there some paint that will stick to the plastic?

8-)

Nosebolt · « **Reply #1 on:** February 08, 2009, 02:36:35 PM »

Personally I would use a heat gun/flame gun to remove all the plastic then get it powder coated.

Do the removal yourself as most will charge loads due to time it will take and powder coating expect to pay no more than 40-60 quid, you could even colour code to you wagon.

tedthefed · « **Reply #2 on:** February 08, 2009, 05:55:15 PM »

As said earlier take all plastic off but spray it with amerite or similar.

dxmedia · « **Reply #3 on:** February 08, 2009, 08:50:56 PM »

Stick it in a bonfire

Panic mechanic! · « **Reply #4 on:** February 08, 2009, 09:05:59 PM »

show it the wife, she won't be able to resist picking of all the paint once she see's a loose bit, then get some plasticote from B&Q hey presto job done!

pajero · « **Reply #5 on:** February 09, 2009, 03:53:06 PM »

Thanks for the help. Think I`ll go down the `ammerite route and colour code it. Bugger getting all the plastic off though. :-)

Author Topic: Dog guard refurb (Read 9072 times)

pajero

Dog guard refurb

Nosebolt

(No subject)

tedthefed

(No subject)

dxmedia

(No subject)

Panic mechanic!

(No subject)

pajero

(No subject)