Birty Dastards Jeep Club
Tech Forum => Workshop => Topic started by: big g on December 15, 2011, 08:00:42 PM
-
any idea what tools I need to take and is there an easy way??
Ta in advance
-
They just pull out. But you have to pull hard
This is not ax wind up
-
:icon_eek:
I'm removing the complete headlamp and out else I can grab not just the glass,is it the whole unit ya on about? :017:
-
Yes the complete unit comes out there clipped in
It's a crappy set up
-
Cheers bigZ,you da man :greggmo:
-
If its the same set up as the WJ the whole thing is held in place by those ball-in clip thingies.
Balls on the light and clips in the bodywork. Pull ever so slightly with constant pressure because if
you give it a yank you're likely to pull the plastic clips out of the body. When they crack it is a royal PITA.
Put some grease or vaseline on when you re-fit.
-
fnarrr fnarrrrr
-
Getting theside lights out are a big enough PITA...greasing seems a good idea...
-
If its the same set up as the WJ the whole thing is held in place by those ball-in clip thingies.
Balls on the light and clips in the bodywork. Pull ever so slightly with constant pressure because if
you give it a yank you're likely to pull the plastic clips out of the body. When they crack it is a royal PITA.
Put some grease or vaseline on when you re-fit.
Second the above, its not nice applying that much pressure to the lights but its the only way.
-
All advice spot on lads.
Fitting this weekend so will try the grease tip :icon_super: