Birty Dastards Jeep Club
Tech Forum => Workshop => Topic started by: Cockney Boy on October 28, 2012, 09:39:39 PM
-
Noticed today that I'm getting a funny clicking and squeaking noise from m near side wheel area. Could it be the DS UJ or bearing or both? The sound does simmer down after a while.
Answers on a post card.....
-
Have you run over a dolphin ...
I'll get me coat :003:
-
cardan joint
-
:iagree:
-
What's your recommendations on a replacement one? Worth upgrading or stick with a standard one?
-
grease it first
-
It will be stuffed (should have greased it in the past) get it refurbished professionally.
-
I've always greased them before and after events, who would be a good refurb company to use?
-
I've used reco-prop in Luton. Top job but not cheap if you ask for quick turnaround
-
Might give them a bell tomorrow, think they charge an inspection fee, but least its local
-
or chards in bristol, or bailey morris
-
grease costs nearly nothing and worth try first you might be lucky
-
grease costs nearly nothing and worth try first you might be lucky
Agreed :)
-
a needle greaser is needed and put in to the rubber cup to hopfully save the post
-
Inspected the shaft today and there is play in the lower UJ and some slight movement in the slide post too. Will be taking it off on Sunday, but the four bolts at the TC end look like fun to remove :jpshakehead:
-
Inspected the shaft today and there is play in the lower UJ and some slight movement in the slide post too. Will be taking it off on Sunday, but the four bolts at the TC end look like fun to remove :jpshakehead:
Indeed they are a SHIET!!!
-
drop the skid plate, support the transmission and its easy.
Time for a clean up whilst your under there too :icon_winkle:
-
drop the skid plate, support the transmission and its easy.
Time for a clean up whilst your under there too :icon_winkle:
Steve you little sinner - dropping the skid can also be a problem if you have a sized bolt.
-
aha Peter
im a saint, skid is dropped after froading so always well lubed, thank you matron :icon_winkle:
-
I have a nasty feeling that a few of the rivnuts are loose, and I don't have a half inch or 12mm tool to replace them :(
-
See told yeah!!!
-
in that case then it will be like decorating your hall through the letterbox :icon_winkle:
-
Will try my new 72" extension bar and an Umpa Lumpa