Topic: underhood welder (Read 7214 times)

Bubba · « **on:** October 01, 2005, 04:04:03 PM »

yup want one real bad but dont want to spend to much coin ideas please

UKJeeper · « **Reply #1 on:** October 01, 2005, 04:57:38 PM »

You can get the small arc welder setups that connect to your battery (both batteries if you got 'em). They are supposed to work OK.

Link 1

Great setup.

Most of the "real" underhood welders require a swap in of a much stronger alternator, usually 220 amps or up. They can cost MONEY!! But if you were going to get one of those. I'd recommend the Premier Welder. Can run MIG or ARC, and has a useful 110v outlet on it.

isle of man · « **Reply #2 on:** October 01, 2005, 05:14:40 PM »

you could try http://www.premierpowerwelder.com/ready ... yweld.html
i have this in my wrangler in place of the passenger air bag alternatively there is a mounting bracket at kilby enterprises for under the bonnet.
and this option.
http://www.powermastermotorsports.com/accessories.html

peter henry

Anonymous · « **Reply #3 on:** October 01, 2005, 11:28:43 PM »

If you can find an alternator with an external regulator, remove the regulator and you have 110V usually

then you just need wires...

Or... 2 - 3 heavy duty batteries in parallel and a fine arc stick and that'll do it too....

I'll try to find the site where I found the write ups on it...

Bubba · « **Reply #4 on:** October 01, 2005, 11:43:20 PM »

no real control with batterys its just ZZZAP

Anonymous · « **Reply #5 on:** October 01, 2005, 11:56:23 PM »

The alternator route is pretty good, you controll the power with Revs..

http://http://www.pirate4x4.com/tech/on-boardwelder/

http://http://www.huv.com/jon/jeep/Welder/on-board-welder.html

http://http://www.zena.net/htdocs/welders/weldspec.shtml

Author Topic: underhood welder (Read 7214 times)

Bubba

underhood welder

UKJeeper

(No subject)

isle of man

welder

Anonymous

(No subject)

Bubba

(No subject)

Anonymous

(No subject)