Birty Dastards Jeep Club

Please login or register.

Login with username, password and session length
Advanced search  
Pages: [1]   Go Down

Author Topic: Making own rocker panels  (Read 5655 times)

0 Members and 1 Guest are viewing this topic.

ajlunt

  • Guest
Making own rocker panels
« on: May 19, 2008, 04:26:30 PM »
Do you think it's possible to make my own rocker panel protectors out of diamond sheet aluminium for YJ. If so do you think it's worth it?
Logged

greggmo

  • Founder
  • Forum Member
  • *
  • Guru: 2
  • Offline Offline
  • Posts: 8230
(No subject)
« Reply #1 on: May 19, 2008, 08:07:33 PM »
it all depends if you intend getting stuck in enough to possibly damage your body. if so then yes it is worth protecting the tub as best you can. steel is best but heavy.
Logged

Mike Pavelin

  • Guest
(No subject)
« Reply #2 on: May 19, 2008, 09:22:19 PM »
If you screw or rivet aluminium to steel it'll rot like F**ck.
Logged

ajlunt

  • Guest
(No subject)
« Reply #3 on: May 19, 2008, 09:38:27 PM »
So steel sheet plate then. Does it need to be flat plate or best to have a lip on the bottom?
Logged

Tragic

  • Guru
  • *
  • Guru: 0
  • Offline Offline
  • Posts: 843
  • Vehicle: A proper Jeep!
  • Year: 1993
(No subject)
« Reply #4 on: May 19, 2008, 10:27:36 PM »
I used 3"x3" steel angle, drilled and bolted through the tub. You can support the entire weight of the Jeep on them, and it cost me £15 :supz:


Logged
Pages: [1]   Go Up
« previous next »
 
Powered by EzPortal