Birty Dastards Jeep Club

Please login or register.

Login with username, password and session length
Advanced search  
Pages: [1]   Go Down

Author Topic: Oil Filters  (Read 2526 times)

0 Members and 1 Guest are viewing this topic.

Nosebolt

  • Guest
Oil Filters
« on: November 29, 2009, 12:50:43 AM »

besides the obvious fitment specs, dia of seal, thread and wether its male or female, what else dictates the filters that are suitable.

the reason i ask is i have 3 oil filters that all say are for the 360,
the one on the 256 also fits the 360 a PH25 approx 5" long and 4" dia,
then there is the one that came on the V8 a Mann filter that is about 3" dia and 8" long
and i have a new Masterparts filter at about 3" dia and 4" long.

they obviously have different capacities but could these size difference affect flow rate and filtration performance or should i trust the manufactures application listings?
Logged

Dave69

  • Club Member
  • Forum Member
  • *
  • Guru: 15
  • Offline Offline
  • Posts: 9457
  • Vehicle: CJ-7 4.2 auto
  • Year: 1979
Re: Oil Filters
« Reply #1 on: November 29, 2009, 07:06:51 PM »

each manufacturer will have it's own specification and what they think is suitable for the engine. All will do the job adequately. what you have to look at is the std size filter and refer to that. i wouldn't go smaller but all will filter the oil as they should, MANN filters are always on the larger size and are of good quality
Logged
XJ 2.5 diesel - dead. XJ 4.0 6" lift - sold to some lucky person
CJ7 4.2 auto standard(ish)
Alfa 147 jtdm

doublej

  • Guest
Re: Oil Filters
« Reply #2 on: December 04, 2009, 06:21:19 PM »

bigger in this area will always be better. i dont see you finding a filter so large it would do harm
Logged

Green Jeep

  • Guest
Re: Oil Filters
« Reply #3 on: December 05, 2009, 10:15:24 PM »

There is alot of other stuff in oil filters...

Pressure relief valve... they have different pressure settings as well.

Anti Siphon Valve... anti drain valve... stand pipe...

The media (paper) can be treated for different properties, long life, finer filtration....

Worked in filtration for 10 years, TJ filters, British Filters, Wix filters...

Personally for my Jeeps I buy Mopar filters, for the couple extra £/$'s it really isn't worth messing about. M&H, Mahle are excellent aftermarket filters. I have seen and tested a lot of lesser brands that in short where crap and didn't actually filter.... Oil and filter are one of the few things that look after your engine, I wouldn't mess about... also do not over change your filters, they need some muck on them to work properly, when new they are more 'open'... if they filtered perfectly from the start they would block up very quickly.

Also worth noting American made filters have the pressure relief valve at the top of the filter so when it open (cold mornings) the oil doesn't have to pass all the dirty media, possibly picking up crap before by passing the filter cycle....

So in short, stick to the filters that are listed, unless the manufacturer can check every other detail in the filter is the same...

Hope this helps, Maf
Logged

Bishops Finger

  • Guest
Re: Oil Filters
« Reply #4 on: December 06, 2009, 12:01:10 AM »

How do you rate Man  & hummell????
Logged

Bubba

  • "Cooter"
  • Marshal
  • Guru
  • *
  • Guru: 69
  • Offline Offline
  • Posts: 21029
Re: Oil Filters
« Reply #5 on: December 06, 2009, 10:04:46 AM »

is that a skiffle band
Logged


trucks


shedric
cletus
mr whippy

I spent most of my money on alcohol, women and old  iron........ the rest of it I just wasted.

Bishops Finger

  • Guest
Re: Oil Filters
« Reply #6 on: December 06, 2009, 11:18:51 AM »

Logged

Mike Pavelin

  • Guest
Re: Oil Filters
« Reply #7 on: December 06, 2009, 11:27:25 AM »

Genuine Mopar often cost less anyway
Logged

Green Jeep

  • Guest
Re: Oil Filters
« Reply #8 on: December 11, 2009, 06:37:21 PM »

How do you rate Man  & hummell????

Mann & Hummel are excellent quality, I have visited one of their sites and we even sold some of our filters to them, they checked the samples that we sent properly for performance and durability.

No filter company makes all of their range, they all sell to each other, it's important that they don't buy from a cheap crap source...

Hope this helps, Maf
Logged

Bishops Finger

  • Guest
Re: Oil Filters
« Reply #9 on: December 12, 2009, 09:54:07 AM »

Cheers mon...buy M&H for work stuff
Logged
Pages: [1]   Go Up
 

Powered by EzPortal