Topic: 4.7 V8 -hard to start the engine (Read 1687 times)

Stempel · « **on:** November 20, 2010, 07:28:05 PM »

Hello All

My trouble appeared just few days ago.I'm trying to start the engine and it's very hard .I need to pump on accelerate for good 10 sec before it starts and when started it smokes from exhaust for another few secs and petrol smells around.It only happens on cold engine.

I doesn't happens always because other times it starts normally.Any ideas what's the problem??

Mike Pavelin · « **Reply #1 on:** November 20, 2010, 07:40:22 PM »

Tomorrow morning switch the ignition on, wait 2 seconds, switch on again, then crank. If it fires up straight away, it's a seal failed inside the fuel pump allowing rail pressure to leak back to the tank.

Stempel · « **Reply #2 on:** November 21, 2010, 12:02:13 PM »

Exactly as you said.
It started up straight away without any smoke and when I started it ,info"done"appeared on the computer.
Any chance to change this seal on my own??

Bubba · « **Reply #3 on:** November 21, 2010, 01:34:33 PM »

is there a reason this will be a big problem sounds worth waiting a few seconds unless the repair is so easy even bulldog could do it

Bulldog67 · « **Reply #4 on:** November 21, 2010, 02:09:49 PM »

it would have to be a clean repair if i was attemptin it

Panic mechanic! · « **Reply #5 on:** November 21, 2010, 04:52:41 PM »

puff.

Mike Pavelin · « **Reply #6 on:** November 21, 2010, 05:45:29 PM »

There is a repair kit available from Chrysler. The fuel tank has to come out though.

Author Topic: 4.7 V8 -hard to start the engine (Read 1687 times)

Stempel

4.7 V8 -hard to start the engine

Mike Pavelin

Re: 4.7 V8 -hard to start the engine

Stempel

Re: 4.7 V8 -hard to start the engine

Bubba

Re: 4.7 V8 -hard to start the engine

Bulldog67

Re: 4.7 V8 -hard to start the engine

Panic mechanic!

Re: 4.7 V8 -hard to start the engine

Mike Pavelin

Re: 4.7 V8 -hard to start the engine