Birty Dastards Jeep Club

Please login or register.

Login with username, password and session length
Advanced search  
Pages: [1]   Go Down

Author Topic: Oh not now....Grand heater issues..  (Read 1602 times)

0 Members and 1 Guest are viewing this topic.

scrw

  • Guest
Oh not now....Grand heater issues..
« on: December 14, 2010, 04:39:47 PM »

..Got the WJ heater blend door issues today, Have a drive up to Newcastle in the morning, will be chilly now. Both doors playing up it seems, have codes 45,55 &56  :banghead:
Logged

carljh

  • Guru
  • *
  • Guru: 0
  • Offline Offline
  • Posts: 167
Re: Oh not now....Grand heater issues..
« Reply #2 on: December 15, 2010, 01:03:17 PM »

the two going for £87 keep the duel control, the one from heater treater uses only the motor on the glove box side
so both doors are held together with small grub srews on centre shaft.
just make sure the motors work before you pick one. you can just reach the back motor to feel the spindle to make sure
it moves when you work the temp control
Oh and try not to use a dremmel type cutter very messy. I drilled a hole at each corner and then cut it with a saw blade on a
swiss army knife. a lot cleaner and safer.
Logged

charger

  • Guest
Re: Oh not now....Grand heater issues..
« Reply #3 on: December 16, 2010, 08:09:40 PM »

I have this problem too drivers side there is no hot air is the the door blend how do you get those codes, do you have to take the dash out or can you just buy one of them kits where you take the glove box out.
Logged

Green Jeep

  • Guest
Re: Oh not now....Grand heater issues..
« Reply #4 on: December 16, 2010, 09:56:32 PM »

Buy the kit, follow the instructions and note the bit when your cutting through stuff... dremel is a top tip...

Warmth will then flow again....
Logged
Pages: [1]   Go Up
 

Powered by EzPortal