November 15, 2024, 03:30:27 PM
Welcome,
Guest
Please
login
or
register
.
1 Hour
1 Day
1 Week
1 Month
Forever
Login with username, password and session length
Home
Garage
Forum
Help
Login
Register
GALLERY
Unread
Events
Birty Dastards Jeep Club
>
Forum
>
Tech Forum
>
Workshop
>
Topic:
electrical fault- help needed!
« previous
next »
Pages: [
1
]
Go Down
Print
Author
Topic: electrical fault- help needed! (Read 1210 times)
0 Members and 1 Guest are viewing this topic.
kevinthetank
Guest
electrical fault- help needed!
«
on:
July 26, 2012, 06:23:47 PM »
My 93 YJ has just failed MOT on a fault with the indicators and I'm a bit puzzled with where to start.
Essentially, the four ways work fine but if I indicate in either direction, some of the indicators on the opposite side come on too
.
Any ideas or pointers?? Any regular faults with this system?
Thanks for any help!
Logged
Cockney Boy
Guest
Re: electrical fault- help needed!
«
Reply #1 on:
July 26, 2012, 06:32:47 PM »
I think someone else had a similar problem on the forum, but you'll be looking at an earth fault somewhere on your switch, also try a different relay
Logged
isle of man
بعض العضو التناسلي النسوي...
Club Member
Forum Member
Guru: 6
Offline
Posts: 11537
Vehicle: G-Class AKA “The G spot”
Take the road less travelled...
Re: electrical fault- help needed!
«
Reply #2 on:
July 26, 2012, 06:43:02 PM »
Try changing the hazard switch.
Logged
"Not all those who wander are lost"
bigjeepzj
Club Member
Guru
Guru: 22
Offline
Posts: 3438
lift it, brake it, Fix it brake it, fix it again
Re: electrical fault- help needed!
«
Reply #3 on:
July 26, 2012, 06:45:20 PM »
or pull the hazard flasher only relay and check if the the indicators work okl
Logged
Delk
Guest
Re: electrical fault- help needed!
«
Reply #4 on:
July 28, 2012, 12:21:23 PM »
Several times I have had to wash the inside of my TJ out and the indicators have gone nuts until the switch dried out a bit.
This morning I changed the switch because they didn't work until you giggled them back and forth for a few minutes. The switch is the same as a Cherokee so I picked one up cheap and now they work fine.
I opened my original switch up to see what was inside. The contacts were covered in a greenish blue swamp goo.this whole mess could make the lights do all kinds of tricks.
Logged
Print
Pages: [
1
]
Go Up
« previous
next »
Birty Dastards Jeep Club
>
Forum
>
Tech Forum
>
Workshop
>
Topic:
electrical fault- help needed!
Powered by
EzPortal
Go Up
Go Down