Birty Dastards Jeep Club

Please login or register.

Login with username, password and session length
Advanced search  
Pages: [1]   Go Down

Author Topic: Fitting CB Radio  (Read 2208 times)

0 Members and 2 Guests are viewing this topic.

Mike2909

  • Guest
Fitting CB Radio
« on: February 16, 2014, 11:36:46 AM »

I am fitting a CB Radio into the Wrangler and have a couple of questions.

What is the best place for the CB and aerial?
Do I need to use an SWR meter when I am fitting the aerial?

Logged

Nosebolt

  • Guest
Re: Fitting CB Radio
« Reply #1 on: February 16, 2014, 11:48:08 AM »

CB - anywhere you can easily reach it

Aerial - as near to the centre of the vehicle as possible, but don't panic as the directional variance won't affect normal off road use, also consider things like bushes catching etc.

SWR - yes

Logged

bigjeepzj

  • Club Member
  • Guru
  • *
  • Guru: 22
  • Offline Offline
  • Posts: 3438
  • lift it, brake it, Fix it brake it, fix it again
Re: Fitting CB Radio
« Reply #2 on: February 16, 2014, 12:06:36 PM »

 :iagree:
Logged

Cockney Boy

  • Guest
Re: Fitting CB Radio
« Reply #3 on: February 16, 2014, 12:17:07 PM »

Just next to the off side rear light cluster. You can get brackets that will screw behind the light
Logged

bgbazz

  • Guru
  • *
  • Guru: 0
  • Offline Offline
  • Posts: 4925
  • Vehicle: Was a KJ, now a VW
  • Year: 2003
Re: Fitting CB Radio
« Reply #4 on: February 16, 2014, 12:51:14 PM »

Defo have to SWR the antenna...any time you change the mounting position is a good idea as well.
Logged

Mike2909

  • Guest
Re: Fitting CB Radio
« Reply #5 on: February 16, 2014, 03:11:18 PM »

Just next to the off side rear light cluster. You can get brackets that will screw behind the light

Do you know where I can find that type of bracket?
Logged

wildwood

  • The 1 Tonne Kid
  • Marshal
  • Forum Member
  • *
  • Guru: 14
  • Offline Offline
  • Posts: 5921
Re: Fitting CB Radio
« Reply #6 on: February 16, 2014, 04:34:21 PM »

I have a bracket that attaches to your spare tyre bump stop on the right side of the Jeep.
It clamps on the tyre stop and has a hole in it for the aerial. never used it .......yours for a Jaffa or two if you want it give us a shout.
Logged

bgbazz

  • Guru
  • *
  • Guru: 0
  • Offline Offline
  • Posts: 4925
  • Vehicle: Was a KJ, now a VW
  • Year: 2003
Re: Fitting CB Radio
« Reply #7 on: February 16, 2014, 05:00:48 PM »

I have mine attached to the side mirror assy, but because it has a magnetic base, I can put it anywhere I like.
Logged

bigjeepzj

  • Club Member
  • Guru
  • *
  • Guru: 22
  • Offline Offline
  • Posts: 3438
  • lift it, brake it, Fix it brake it, fix it again
Re: Fitting CB Radio
« Reply #8 on: February 16, 2014, 05:03:51 PM »

Just next to the off side rear light cluster. You can get brackets that will screw behind the light

Do you know where I can find that type of bracket?
Ebay is your friend
there's a few type on there
Logged

bgbazz

  • Guru
  • *
  • Guru: 0
  • Offline Offline
  • Posts: 4925
  • Vehicle: Was a KJ, now a VW
  • Year: 2003
Re: Fitting CB Radio
« Reply #9 on: February 16, 2014, 05:54:32 PM »

CBs and antenna mounts is something I have been messing around with with for many years and I've had many different rigs of all sizes and varieties fitted on dozens of my vehicles. The correct antenna, fitted in the correct position is the key to reliable performance in any case scenario! You can choose a gutter mount, bracket mount, suction mount or a magnetic mount which give you a heap of choices..it still gets down to where you put it!  One of the most popular mounting positions for close work is on the front bull/scrub bar, simply because you can see it and avoid situations where it might be knocked off. Anywhere up high, gutter or roof centre (the best) is very good, but you may drive for a while before you realise it's gone. You really need to think about what sort of performance you require from the radio, particularly when transmitting...even the most high spec, powerful CB will perform like a piece of crap if the antenna isn't set up and SWR'd properly.

I currently have a  President Jackson II ASC fitted in the dash of the Nissan and it's hooked to a small antenna sitting beside my side mirror for local work...the radio is a fully UK/EU legal rig and on most days I can and do, listen to people chattering in the UK, USA, Australia and everywhere in between...I usually can't talk to them until I jump out and reposition the antenna up on the centre of the roof. The radio itself works in AM, FM, LSB and USB and is probably a bit of an overkill for most folk, but I love it! Peter Henry has one of them, fitted in his 75.

Getting back to original subject...a lot depends on what you intend using the radio for. Laning with a group, when you are only 100 yards apart, you can stick it where you like...if you are going a bit further afield, by yourself, start giving it all some thought!


Hope this helps.................................................and it makes no difference where you mount the radio....just make sure you can reach it when it matters!!!
Logged

just-boot-it!

  • Guest
Re: Fitting CB Radio
« Reply #10 on: February 16, 2014, 06:15:48 PM »

Would have been fitting mine you supplied baz but our responder members going to assist the floods in somerset took priority today.
Logged

bgbazz

  • Guru
  • *
  • Guru: 0
  • Offline Offline
  • Posts: 4925
  • Vehicle: Was a KJ, now a VW
  • Year: 2003
Re: Fitting CB Radio
« Reply #11 on: February 16, 2014, 06:50:12 PM »

Understood Jay...I think I may have heard them today. I need a callsign or two to be sure. Had a group operating in South Wales somewhere this morning..absolutely booming in!
Logged

Mike2909

  • Guest
Re: Fitting CB Radio
« Reply #12 on: February 16, 2014, 08:11:51 PM »

There is not much room to fit anything extra lol
Logged

Obarno

  • Guest
Re: Fitting CB Radio
« Reply #13 on: February 17, 2014, 09:02:44 AM »

I have mine mounted through the bonnet. It's far enough back not to be dangerous but also allows you to open the bonnet. It gives good reception and transmission and works well on both UK and EU channels.
Logged

YT

  • Guest
Re: Fitting CB Radio
« Reply #14 on: February 17, 2014, 10:39:59 AM »

 I'm running an Intek 720+ with a full length Stinger mounted through the roof (just above my head) and also have a K40, again through the roof, but dead center. Both give really good reception. The K40 does give a bit more range. Both were set up by the bro in law. (Ex sigs)
I was parked up outside Kent & Canterbury Hospt, and was chatting to a bloke in Co Donegall. I suspect he was on amature radio, he was filling the scale on my set and crystal clear, said I was reaching him at similar levels. :)
Logged

bgbazz

  • Guru
  • *
  • Guru: 0
  • Offline Offline
  • Posts: 4925
  • Vehicle: Was a KJ, now a VW
  • Year: 2003
Re: Fitting CB Radio
« Reply #15 on: February 17, 2014, 10:47:51 AM »

The secret is the antenna....if you and I were both to set up a quarter wave antenna on  15 foot mast on a bit of high ground, away from houses or big obstacles, we could very easily and clearly talk to each other. I had a similar setup back in Oz and spoke on a regular basis to people in Europe.
Logged

YT

  • Guest
Re: Fitting CB Radio
« Reply #16 on: February 17, 2014, 12:17:20 PM »

The stinger could well be going, to allow fitting of an external PMR antenna. It will give a bit more range on the 5w handheld PMR, but more importantly, will work with a vehicle set, as our local response group now have the license to run 25w vehicle sets, so much better range. :)
Logged

bgbazz

  • Guru
  • *
  • Guru: 0
  • Offline Offline
  • Posts: 4925
  • Vehicle: Was a KJ, now a VW
  • Year: 2003
Re: Fitting CB Radio
« Reply #17 on: February 17, 2014, 12:57:41 PM »

With that sort of grunt, I'll have no problem hearing you..mine works up around 40W when I need to, but I won't be bothering you guys when you're busy! Channel 35, Upper sideband , is a good place to lurk.
Logged
Pages: [1]   Go Up
 

Powered by EzPortal