Birty Dastards Jeep Club

Please login or register.

Login with username, password and session length
Advanced search  
Pages: [1]   Go Down

Author Topic: Where?where?where?  (Read 5154 times)

0 Members and 1 Guest are viewing this topic.

dodgyjeep

  • Guest
Where?where?where?
« on: May 02, 2006, 08:41:50 PM »
Alright yow lot

Got my husky mats winging there way over from the good ole u s of a and are getting ready to take the tj out for the first time since i bought her

just a few questions

where do you lot keep your hi lift as i have tried in the "boot" and it aint gonna fit

and also where have you mounted your cb, i cannot mount it on top of the dash because i have my locker switches mounted there

There is mounting kit on e bay but it requires a support bar running from one side of the roll bar to the other which i do not seem to have!!should I???

cheers in advance

mark :)
Logged

Dodster

  • Guest
(No subject)
« Reply #1 on: May 02, 2006, 08:56:13 PM »
I tried the hi lift everywhere and went for fitting it on the bonnet like others have only i used modified 4x rac brackets.. (pic in album)
I know some folks have strapped theirs to the roll bars in the rear... 8)

Hope thats of some use  :D
Logged

dodgyjeep

  • Guest
(No subject)
« Reply #2 on: May 02, 2006, 09:41:57 PM »
had a look at your album..nice truck

like the look of your sill protectors, what make are they?

cheers

mark
Logged

Dodster

  • Guest
(No subject)
« Reply #3 on: May 02, 2006, 10:27:36 PM »
Cheers
           they were from Mountain Jacks who have since sold up and gone on to pastures new.

There are some similar at 4wd and Qtech i think they are Olympic rock rails..  :D
Logged

Anonymous

  • Guest
(No subject)
« Reply #4 on: May 02, 2006, 10:48:14 PM »
Believe they were MJ custom jobs.....

Olympics do a good job check out 4wd or Quadratec to source them

Think Ponyracer and possibly Mik may also be able to offer something?
Logged

Woody

  • Guest
(No subject)
« Reply #5 on: May 06, 2006, 10:54:24 AM »
Dodgy

I have mine across my rear bars, you can see it in some of the photos here http://www.jeepclub.co.uk/reports.cfm?id=287 green TJ with yellow advertising down the bonnet.  I just got 4 exhaust U bolts that fitted round the sports bar and 2 lenghts of square steel tubing across the gap.  Then bolted the 4xRac mounts to the tubing.

Must admit to being tempted by the bonnet mounting kits though.

Woody
Logged
Pages: [1]   Go Up
« previous next »
 
Powered by EzPortal