Birty Dastards Jeep Club

Please login or register.

Login with username, password and session length
Advanced search  
Pages: [1]   Go Down

Author Topic: Getting wires through a YJ firewall  (Read 3658 times)

0 Members and 1 Guest are viewing this topic.

decaman

  • Guest
Getting wires through a YJ firewall
« on: March 08, 2015, 01:16:29 PM »
Any easy access routes to make use of?

Hesitant to start poking coat hangers around through grommets.

Hoping there's an easy route.
Logged

j33pky

  • Guest
Re: Getting wires through a YJ firewall
« Reply #1 on: March 08, 2015, 02:13:46 PM »
80mm hole saw?
Logged

decaman

  • Guest
Re: Getting wires through a YJ firewall
« Reply #2 on: March 08, 2015, 02:24:37 PM »
Hoping to avoid that if possible.
Logged

eastryjeep

  • Guest
Re: Getting wires through a YJ firewall
« Reply #3 on: March 08, 2015, 04:26:56 PM »
Use a wooden kebab skewer as opposed to a coat hangar, much less likely to gouge th insulation off other wires.
If many wires need to go through bulkhead, get some blanking grommets (Halfords), make hole in centre, bind wires in tape to match hole in grommet and seal with RTV sealant on both sides of grommet when installed.
Logged

Dave69

  • Club Member
  • Guru
  • *
  • Guru: 15
  • Offline Offline
  • Posts: 9457
  • Vehicle: CJ-7 4.2 auto
  • Year: 1979
Re: Getting wires through a YJ firewall
« Reply #4 on: March 08, 2015, 09:13:17 PM »
Logged
XJ 2.5 diesel - dead. XJ 4.0 6" lift - sold to some lucky person
CJ7 4.2 auto standard(ish)
Alfa 147 jtdm
Pages: [1]   Go Up
« previous next »
 
Powered by EzPortal