Birty Dastards Jeep Club

Please login or register.

Login with username, password and session length
Advanced search  
Pages: [1]   Go Down

Author Topic: Is this going to do the job......  (Read 4825 times)

0 Members and 2 Guests are viewing this topic.

Groove Rider

  • Guest
Is this going to do the job......
« on: November 07, 2007, 02:12:45 PM »
Will this do the job of pulling out my XJ rear wheel bearings??

http://cgi.ebay.co.uk/NEW-9pce-Auto-Bod ... dZViewItem

Cheap....... but is it nasty :)
Logged

greggmo

  • Founder
  • Forum Member
  • *
  • Guru: 2
  • Offline Offline
  • Posts: 8230
(No subject)
« Reply #1 on: November 07, 2007, 05:33:11 PM »
it should certainly help. ya can always just destroy the old bearings as long as you dont send bits down the tube into the pumpkin.
Logged

Mik

  • Guest
(No subject)
« Reply #2 on: November 09, 2007, 11:06:36 AM »
All you need is a 12 point 1/4 ring spanner and a length of steel rod about 20mm diameter, a foot longer than your axle.

Use the spanner to release the screw in the diff holding the cross pin in. Remove ( or half remove) the cross pin and then insert your rod in the axle, through the diff and use it to punch out the bearings from behind.

Peasey.
Logged

greggmo

  • Founder
  • Forum Member
  • *
  • Guru: 2
  • Offline Offline
  • Posts: 8230
(No subject)
« Reply #3 on: November 09, 2007, 08:34:42 PM »
or like mik said ya can do it the engineers way :lol:
Logged
Pages: [1]   Go Up
« previous next »
 
Powered by EzPortal