Birty Dastards Jeep Club

Please login or register.

Login with username, password and session length
Advanced search  
Pages: [1]   Go Down

Author Topic: hub asembly  (Read 4618 times)

0 Members and 1 Guest are viewing this topic.

MOCAJ

  • Club Member
  • Forum Member
  • *
  • Guru: 4
  • Offline Offline
  • Posts: 6366
hub asembly
« on: January 27, 2008, 10:54:26 PM »
Today i have been stripping out the front axle on 97 TJ to replace the U joint.

The hub assembly was a stubbon dastard and when i put the puller on it, the 2 parts seperated. Front part came out with studs fitted. I then had to get the rear out with the other half of the bearing. It all came Ok eventually but i have seen a replacement hub assembly is sold as one unit.  :?

Can i just press the 2 parts together after greasing it up  :?:

All seems ok, no play
Logged
short term jeep owner since 2005, every truck is a never ending project. Birtys, the best club in Jeepland

isle of man

  • بعض العضو التناسلي النسوي...
  • Club Member
  • Forum Member
  • *
  • Guru: 6
  • Offline Offline
  • Posts: 11537
  • Vehicle: G-Class AKA “The G spot”
  • Take the road less travelled...
    • http://www.4x4.im
(No subject)
« Reply #1 on: January 27, 2008, 11:03:00 PM »
i would change it.



peter henry
Logged
"Not all those who wander are lost"

greggmo

  • Founder
  • Forum Member
  • *
  • Guru: 2
  • Offline Offline
  • Posts: 8230
(No subject)
« Reply #2 on: January 27, 2008, 11:31:42 PM »
change it for now mate and maybe let us av a look at it with ya when we can. i got a usable spare if ya need it mate 8) in theory it should just pull its self back together but just swap it to be on the safe side.
Logged
Pages: [1]   Go Up
« previous next »
 
Powered by EzPortal