Topic: X J Rear axle (Read 5176 times)

td marmo · « **on:** February 13, 2008, 08:54:36 AM »

HI can any one enlighten me what causes end float on a 4lt limited slip rear end or is it suppost to have a bit of float when wheels are off the ground ?

The Smiths · « **Reply #1 on:** February 13, 2008, 09:38:01 AM »

There is usually up to 3mm of float due to the way they are held in.

Bubba · « **Reply #2 on:** February 13, 2008, 08:14:03 PM »

yup they are retained by a large c clip expect 2 3 mm of end float and no lift at the wheel

greggmo · « **Reply #3 on:** February 13, 2008, 08:42:52 PM »

yup as bubba said this is normal. 8-)

wazza · « **Reply #4 on:** February 14, 2008, 04:55:28 PM »

anymore than that an your slip diff is fecked

td marmo · « **Reply #5 on:** February 14, 2008, 08:11:58 PM »

thanks for your replies is there anything that can be done if there is more than 3 to 4mm of float ?

greggmo · « **Reply #6 on:** February 14, 2008, 09:40:36 PM »

you could replace the c clips first and see how it is after that.

Author Topic: X J Rear axle (Read 5176 times)

td marmo

X J Rear axle

The Smiths

(No subject)

Bubba

(No subject)

greggmo

(No subject)

wazza

(No subject)

td marmo

(No subject)

greggmo

(No subject)