Birty Dastards Jeep Club

Please login or register.

Login with username, password and session length
Advanced search  
Pages: [1]   Go Down

Author Topic: Arc welding on XJ  (Read 5329 times)

0 Members and 1 Guest are viewing this topic.

puggy

  • Guest
Arc welding on XJ
« on: April 09, 2008, 10:25:10 PM »
Hello folks, if I wanted to do a little arc welding on my 97 XJ what parts of the electrical system do I need to disconnect.
On earlier cars simply disconnecting the battery was enough but I would hate to fry something important.
Cheers Puggy
Logged

Mike Pavelin

  • Guest
(No subject)
« Reply #1 on: April 10, 2008, 07:13:37 AM »
I would disconnect the powertrain control module and the battery.
Logged

MuckShifter

  • Guest
(No subject)
« Reply #2 on: April 10, 2008, 06:21:12 PM »
Pull the plug out of the alternator too :wink:
Logged

greggmo

  • Founder
  • Forum Member
  • *
  • Guru: 2
  • Offline Offline
  • Posts: 8230
(No subject)
« Reply #3 on: April 10, 2008, 11:25:22 PM »
remove the earth from the battery. all you need to do is brake the circuit. trust me i am a welder 8-)
Logged

demonicwillow

  • Guest
(No subject)
« Reply #4 on: April 10, 2008, 11:59:25 PM »
Quote from: "greggmo"
remove the earth from the battery. all you need to do is brake the circuit. trust me i am a welder 8-)


I agree, i am a welder by trade too! (jack of all trades here) :wink:
Logged

greggmo

  • Founder
  • Forum Member
  • *
  • Guru: 2
  • Offline Offline
  • Posts: 8230
(No subject)
« Reply #5 on: April 11, 2008, 12:12:18 AM »
mig on boddy for sure but ARC is ok on thick stuff 8-)
Logged

puggy

  • Guest
(No subject)
« Reply #6 on: April 11, 2008, 12:30:35 AM »
Cheers for the advice, the welding I was planning is on the trackbar bracket at the axle end so is fairly heavy duty.
Excuse my ignorance but what is the Powertrain control module and where is it.
Logged
Pages: [1]   Go Up
« previous next »
 
Powered by EzPortal