Topic: TJ Engine Immobiliser Deactivation (Read 8454 times)

PtP · « **on:** August 07, 2008, 12:03:07 AM »

Has anyone tried this little trick to disable the immobiliser on a TJ before? I found the info on the US JeepForum.

Quote

1. Remove any necessary dash panels to gain access to the immobiliser unit wiring (mine was located underneath the steering rack.)

2. Press unlock on the hand sender unit to deactivate the immobiliser. (the dash indicator LED should go out.)

3. Immediately disconnect the immobiliser unit at the jackplug where it joins in to the main loom.

That's it - the immobiliser is disconnected, it can not reactivate and send a signal arming the system.

I was able to put the key in the ignition, turn-it and start her right up.

http://www.jeepforum.com/forum/showthread.php?p=5424365

Mike Pavelin · « **Reply #1 on:** August 07, 2008, 07:31:25 AM »

You can try, but the system on a US Jeep is different to a UK model. Worse thing that can happen is you'll have to put it back together.

MOCAJ · « **Reply #2 on:** August 07, 2008, 06:44:17 PM »

mmm, ok to get me going but the insurance are insisting on some type of immobiliser fitted

hoping a re-programme will cure 8-)

Bubba · « **Reply #3 on:** August 07, 2008, 07:27:03 PM »

like they can see if its working :-?

MOCAJ · « **Reply #4 on:** August 07, 2008, 09:55:34 PM »

this only works if the immobiliser switches off on the key fob

ie, if the system is working normal

mine isn't :twisted:

wrangler · « **Reply #5 on:** August 07, 2008, 11:32:41 PM »

Quote from: "V8 Bubba"

like they can see if its working

OOOOOOOOOOOOOOOOOOOOOOOOOyes!

Author Topic: TJ Engine Immobiliser Deactivation (Read 8454 times)

PtP

TJ Engine Immobiliser Deactivation

Mike Pavelin

(No subject)

MOCAJ

(No subject)

Bubba

(No subject)

MOCAJ

(No subject)

wrangler

(No subject)