Print

Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

[PtP]

I know some of you will have seen this before, but I thought I’d post it here before it gets lost when I pull the JA site.


The photos tell the story, but the new Warn guard does come with a full set of detailed instructions which are very easy to follow.

I did this installation single-handed, but it would have been a lot easier with a second person especially on the re-fit.


Here is the new guard


Up on ramps


The old guard


Access to the filler pipes


Cut the cable tie holding the axle vent pipe


Eight screws removed


Old guard and tank removed


Mud!


Hoses sealed off before pressure washing


Dry run without the tank - it's very heavy. Notice the deflated tyre on the barrow, it was by design!


Tank assembly ready for installation


The fuel pipes have to be fed in first, the barrow was too high so I used the crawler board on axle stands and a jack to start things off


Another bottle jack and plenty of packing to lift the assembly into place a bit at a time


The job's done