Topic: Another CRD with issues (Read 11558 times)

jay140285 · « **on:** December 20, 2011, 02:03:15 PM »

Mother in Laws 2003 WJ CRD is stuck in limp home mode, it has done this a couple of times over the last few months but they ignored it and when turned off and on it was ok.

Now it is in limp home mode max 30mph and wont come out of it.

I am at work so havent had a go at re setting the codes but will do later on my ODBII.

Nat has done the key code finder and got P1130 to do with the 02 sensors, which I cannot see been linked personally but maybe you will say otherwise.

Cheers all.

jeep2.7crd · « **Reply #1 on:** December 20, 2011, 02:44:35 PM »

P1130 is not O2 sensor, it is fuel rail pressure sensor. Does not necessarily mean you have a fault with that sensor as I have the same fault code. But the sensor has checked out ok. Mine had a prob that causes the motor to die on wide open throttle. I think this momentarily causes the rail presure to rise causing that fault code.

Yet to find the real cause....see my post!!

Use below link for fault code meanings for jeeps and wjjeeps.com for loads of WJ info

http://www.wjjeeps.com/faultcodes.htm#DTC

Panic mechanic! · « **Reply #2 on:** December 20, 2011, 02:57:53 PM »

when was the fuel filter last replaced?

jay140285 · « **Reply #3 on:** December 20, 2011, 02:58:15 PM »

Got that link saved on my phone!!

But couldn't see P1130 so googled it.

Yes I have seen your post, does the CRD have a Throttle position sensor?

I only ask as I had mine (V8) failed and it would cut out as yours is?

jay140285 · « **Reply #4 on:** December 20, 2011, 02:58:58 PM »

Quote from: Panic mechanic! on December 20, 2011, 02:57:53 PM

when was the fuel filter last replaced?

Its due a service Rob, would that cause it to be in limp home mode?

daggie · « **Reply #5 on:** December 20, 2011, 03:00:52 PM »

possible a software issue, as in, the merc ecu not talking to the jeep transmission ecu

been there too

jay140285 · « **Reply #6 on:** December 20, 2011, 03:02:37 PM »

Quote from: daggie on December 20, 2011, 03:00:52 PM

possible a software issue, as in, the merc ecu not talking to the jeep transmission ecu
been there too

does it need to go to Jeep?

I mate has a full blown diagnostic reader at his garage, would that read as it whether its this or something else?

Dutch · « **Reply #7 on:** December 20, 2011, 03:04:11 PM »

Yep....scan & new software download & installation by dealer.

Been there tooooooooo

jay140285 · « **Reply #8 on:** December 20, 2011, 03:05:11 PM »

What was the cost Dutch???

sure MIL will ask!

Dutch · « **Reply #9 on:** December 20, 2011, 03:08:15 PM »

Quote from: jay140285 on December 20, 2011, 03:05:11 PM

What was the cost Dutch???

sure MIL will ask!

Surprising really, in my case the gearbox wasn't talking properly with the rest of the truck.

Two coffee's, a car wash, scan & download for £32 squids.

jay140285 · « **Reply #10 on:** December 20, 2011, 03:11:44 PM »

Wolvohampton Jeep want £95 + vat!!!!

tedthefed · « **Reply #11 on:** December 20, 2011, 05:13:40 PM »

Had that problem with mine earlier this year and it turned out to need a Auto Gearbox ECU unit. At friends garage used the DRB unit and then tried another ECU from another car prior to putting the new one on worked since , but dont tell the jeep .

jay140285 · « **Reply #12 on:** December 20, 2011, 06:15:16 PM »

Going to get it booked in for Mother in law at wolvo as she cannot drive it much further at 30mph.

jay140285 · « **Reply #13 on:** December 28, 2011, 06:14:17 PM »

Well, they ended up going to Kings Jeep Cheltenham and Gloucetser as Wolovo couldnt get them in.

Looks like the Transmission Control Unit is goosed. So Jeep want £700plus to sort it out.

Had a look on ebay and no used ones about that I can see, loads for a V8.

Carlos doesnt have any either, so the search continues.

tedthefed · « **Reply #14 on:** December 28, 2011, 07:36:48 PM »

Thats the part i had replaced on mine, (467.34 + vat from the dealer) as dealer supply only.But had a bill from auto elect of £150. for sourcing the problem. Have the old one stuck on the shelf in the garage going to dismantle and see what little is inside.

jay140285 · « **Reply #15 on:** December 28, 2011, 07:41:46 PM »

Yes I recall you having the problem as well. No way around it I guess, was yours plug and play?

tedthefed · « **Reply #16 on:** December 28, 2011, 07:59:18 PM »

Yes plug and checked with the DRB machine and fine. But we did also try one from another jeep to confirm it was that part.

jay140285 · « **Reply #17 on:** December 28, 2011, 08:08:59 PM »

There is one on ebay, £99. Think I may take the punt on that.

isle of man · « **Reply #18 on:** December 28, 2011, 08:32:09 PM »

Quote from: jay140285 on December 28, 2011, 08:08:59 PM

There is one on ebay, £99. Think I may take the punt on that.

Waste of moolar that - go main dealer for fix.

jay140285 · « **Reply #19 on:** December 28, 2011, 08:47:00 PM »

They are struggling with the cost at main dealer. Mother in laws partner hasn't worked for 12months and money tight.

tedthefed · « **Reply #20 on:** December 28, 2011, 10:59:46 PM »

2nd hand one more than likely may have same problem and still may need main dealer to check with the DRB thingy.

Bubba · « **Reply #21 on:** December 28, 2011, 11:01:25 PM »

thats a bit of an arse

jay140285 · « **Reply #22 on:** December 28, 2011, 11:29:11 PM »

Any ideas Kev, spending £500 plus just isn't an option for them at the moment. Its not like we can lend it them at the moment as I need the scooby funds for its replacement.

Bubba · « **Reply #23 on:** December 28, 2011, 11:31:59 PM »

no i dont have any experience with such trickery i take it you cant buy the part and self fit ? is it somthing that has to be fitted the programmed in to the jeep ?

jay140285 · « **Reply #24 on:** December 28, 2011, 11:35:10 PM »

Yes the part is nearly £500 plus vat, and I would fit it.

Hence thinking of trying a second hand one. I put a used gearbox ECU on mine when I was trying to fault find.

How much does the dealer DRB reconfig cost??

Author Topic: Another CRD with issues (Read 11558 times)

jay140285

jeep2.7crd

Panic mechanic!

jay140285

jay140285

jay140285

jay140285

jay140285

jay140285

jay140285

jay140285

jay140285

jay140285

jay140285

jay140285