Topic: A funny clicking and squeaking sound!! (Read 2982 times)

Cockney Boy · « **on:** October 28, 2012, 09:39:39 PM »

Noticed today that I'm getting a funny clicking and squeaking noise from m near side wheel area. Could it be the DS UJ or bearing or both? The sound does simmer down after a while.

Answers on a post card.....

Lornaben · « **Reply #1 on:** October 29, 2012, 12:10:36 AM »

Have you run over a dolphin ...

I'll get me coat

Bubba · « **Reply #2 on:** October 29, 2012, 04:32:00 PM »

cardan joint

isle of man · « **Reply #3 on:** October 29, 2012, 04:55:29 PM »

Cockney Boy · « **Reply #4 on:** October 29, 2012, 05:11:42 PM »

What's your recommendations on a replacement one? Worth upgrading or stick with a standard one?

Bubba · « **Reply #5 on:** October 29, 2012, 05:36:24 PM »

grease it first

isle of man · « **Reply #6 on:** October 29, 2012, 07:50:00 PM »

It will be stuffed (should have greased it in the past) get it refurbished professionally.

Cockney Boy · « **Reply #7 on:** October 29, 2012, 08:27:23 PM »

I've always greased them before and after events, who would be a good refurb company to use?

JamesH · « **Reply #8 on:** October 29, 2012, 08:46:47 PM »

I've used reco-prop in Luton. Top job but not cheap if you ask for quick turnaround

Cockney Boy · « **Reply #9 on:** October 29, 2012, 08:49:04 PM »

Might give them a bell tomorrow, think they charge an inspection fee, but least its local

willo · « **Reply #10 on:** October 29, 2012, 08:55:37 PM »

or chards in bristol, or bailey morris

Bubba · « **Reply #11 on:** October 29, 2012, 09:40:02 PM »

grease costs nearly nothing and worth try first you might be lucky

Cockney Boy · « **Reply #12 on:** October 29, 2012, 09:51:31 PM »

Quote from: Bubba on October 29, 2012, 09:40:02 PM

grease costs nearly nothing and worth try first you might be lucky

Agreed

Bubba · « **Reply #13 on:** October 29, 2012, 10:05:36 PM »

a needle greaser is needed and put in to the rubber cup to hopfully save the post

Cockney Boy · « **Reply #14 on:** November 02, 2012, 04:40:19 PM »

Inspected the shaft today and there is play in the lower UJ and some slight movement in the slide post too. Will be taking it off on Sunday, but the four bolts at the TC end look like fun to remove

isle of man · « **Reply #15 on:** November 02, 2012, 06:59:53 PM »

Quote from: Cockney Boy on November 02, 2012, 04:40:19 PM

Inspected the shaft today and there is play in the lower UJ and some slight movement in the slide post too. Will be taking it off on Sunday, but the four bolts at the TC end look like fun to remove

Indeed they are a SHIET!!!

MOCAJ · « **Reply #16 on:** November 02, 2012, 07:08:00 PM »

drop the skid plate, support the transmission and its easy.

Time for a clean up whilst your under there too

isle of man · « **Reply #17 on:** November 02, 2012, 07:12:55 PM »

Quote from: my other cars a jeep on November 02, 2012, 07:08:00 PM

drop the skid plate, support the transmission and its easy.

Time for a clean up whilst your under there too

Steve you little sinner - dropping the skid can also be a problem if you have a sized bolt.

MOCAJ · « **Reply #18 on:** November 02, 2012, 07:20:50 PM »

aha Peter

im a saint, skid is dropped after froading so always well lubed, thank you matron

Cockney Boy · « **Reply #19 on:** November 02, 2012, 07:26:12 PM »

I have a nasty feeling that a few of the rivnuts are loose, and I don't have a half inch or 12mm tool to replace them

isle of man · « **Reply #20 on:** November 02, 2012, 07:35:55 PM »

See told yeah!!!

MOCAJ · « **Reply #21 on:** November 02, 2012, 07:43:26 PM »

in that case then it will be like decorating your hall through the letterbox

Cockney Boy · « **Reply #22 on:** November 02, 2012, 07:57:39 PM »

Will try my new 72" extension bar and an Umpa Lumpa

Author Topic: A funny clicking and squeaking sound!! (Read 2982 times)

Cockney Boy

Cockney Boy

Cockney Boy

Cockney Boy

Cockney Boy

Cockney Boy

Cockney Boy

Cockney Boy