Birty Dastards Jeep Club

Please login or register.

Login with username, password and session length
Advanced search  
Pages: 1 [2]   Go Down

Author Topic: Starting ?  (Read 7832 times)

0 Members and 1 Guest are viewing this topic.

Manda

  • AKA Dangerous Doris
  • Founder
  • Forum Member
  • *
  • Guru: 0
  • Offline Offline
  • Posts: 3322
(No subject)
« Reply #25 on: August 28, 2006, 11:53:05 AM »
As far as I know the 4.2's are carbs, so they have a big round air filter on the top. (Unless they've had an injection system added). They also tend to be in older models e.g. CJ's, early YJ's etc.
Logged
AKA Dangerous Doris

Anonymous

  • Guest
(No subject)
« Reply #26 on: August 28, 2006, 11:55:46 AM »
My Log book tells me Mines a 2.5. I checked it with Jeep and it was built as a 4.0! I tried telling them and they still didn't change it. Just sent it back with 2.5 on it again.

EE
Logged

Manda

  • AKA Dangerous Doris
  • Founder
  • Forum Member
  • *
  • Guru: 0
  • Offline Offline
  • Posts: 3322
(No subject)
« Reply #27 on: August 28, 2006, 12:02:04 PM »
Ed - my log book says it's a 2.5, as far as I can remember this refers to the model not the engine size. Like referring to YJ's as hard tops and TJ's as soft tops.

Plum - the carry over bit Mark was referring to is when Chrysler 'used up' older engines in newer models, 258 the cylinder capacity of a 4.2l in cubic inches. They did this with some YJ's, using a 'CJ engine' in the new models.
Logged
AKA Dangerous Doris

Anonymous

  • Guest
(No subject)
« Reply #28 on: August 28, 2006, 07:25:02 PM »
Macs Mums log book calls it a 2.5 also but has 3960 as the engine size  :wink:
Logged

Plum

  • Guest
(No subject)
« Reply #29 on: August 29, 2006, 05:00:53 PM »
Quote from: "Manda"
Ed - my log book says it's a 2.5, as far as I can remember this refers to the model not the engine size. Like referring to YJ's as hard tops and TJ's as soft tops.

Plum - the carry over bit Mark was referring to is when Chrysler 'used up' older engines in newer models, 258 the cylinder capacity of a 4.2l in cubic inches. They did this with some YJ's, using a 'CJ engine' in the new models.


Cheers Manda . . . . . .

my motor seems to be a bit of a strange one as even the local steeler cannot come up with anything as the chassis no is 3 digits short of the norm an doesent exist on the world jeep data base (apparently) . . . . .. .

therefore am gonna get in touch with JEEP an see if they can shed some light . . . . . .. once againe cheers . . . . .
Logged

Plum

  • Guest
(No subject)
« Reply #30 on: August 29, 2006, 05:08:23 PM »
Quote from: "Manda"
Ed - my log book says it's a 2.5, as far as I can remember this refers to the model not the engine size. Like referring to YJ's as hard tops and TJ's as soft tops.

Plum - the carry over bit Mark was referring to is when Chrysler 'used up' older engines in newer models, 258 the cylinder capacity of a 4.2l in cubic inches. They did this with some YJ's, using a 'CJ engine' in the new models.


Cheers Manda . . . . . .

my motor seems to be a bit of a strange one as even the local steeler cannot come up with anything as the chassis no is 3 digits short of the norm an doesent exist on the world jeep data base (apparently) . . . . .. .

therefore am gonna get in touch with JEEP an see if they can shed some light . . . . . .. once againe cheers . . . . .
Logged

Mike Pavelin

  • Guest
(No subject)
« Reply #31 on: August 29, 2006, 05:30:19 PM »
If it hasn't got a 14 digit VIN, it might be a Chinese one. They're made by Bejing Jeep, and DaimlerChrysler don't hold any information on them.
Logged

Plum

  • Guest
(No subject)
« Reply #32 on: August 29, 2006, 05:46:37 PM »
Ahhhh  . . . .. . interestin so where do i go from here then my good man  . . . . . . . .

you are the first person to shed any light at all on this . . . . . . . . .

wish id av known earlier cos my lads just come back from China e could av done some donky work for me  :lol:  :lol:
Logged
Pages: 1 [2]   Go Up
« previous next »
 
Powered by EzPortal